Question about Land Rover Discovery

Open Question

Hi i have 95 dicovery which is not cranking also it has a red led on continus when i try to start i here this faint click

Posted by RUSH KARUN on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 ford explorer cranks but wont start had this change the relay,fuelpump,sarter,altnator ,battery, wait then it starts


What could cause a 95 Ford Explorer to turn over but not start? It could be a lot of things causing it not to start. If it is turning over it could be the alternator or carburetor causing it not to start. An alternator is an electromechanical device that converts mechanical energy to electrical energy in the form of alternating current. -------------------------------------------------------------------------------
led work light

Apr 12, 2013 | 1995 Ford Explorer

1 Answer

Why won't it crank over?


Sounds like the starter. The faint click would be the starter solenoid, trying to operate starter. Have it tested.

May 05, 2012 | Cars & Trucks

1 Answer

Hi , my 95 dicovery wont change to 4th gear? pls help? mean while i replaced the gear to a 5 speed. every morning, it wont change into 2 untill it gets hot and then changes normally till the 3rd gear and...


You may have a bad clutch disc or pressure plate. You may have a bad transmission. Have you checked the master cylinder? I guess it may be a release bearing. Has this been going on ever since you changed to a 5 speed?

Mar 01, 2011 | 1995 Land Rover Discovery

1 Answer

Is there an ALDL port on a legend ...to plug in a scan tool


There is a connector but it is not like the connector used in the newer 1996 OBD2 cars, your year uses OBD1, here is how you check for codes in this car.

Acura OBD1 Codes Retrieval
Acura vehicles 1986-95 obd1 code retrieval
There are a few different ways to retrieve the codes for "check engine light" for Acura vehicles. One method is to use a led light (sometimes 2 led lights) on the computer or controller box itself. If it has 2 led lights, the color is red and amber. The red is used for flashing the codes whereas the amber is used for adjustment. If you have only a single led light indicator, then that is used for flashing the code.
The controller box can be found by lifting the carpet of the passenger side front foot well or floorboard. You can see the led lights without removing the controller. On other models, you can find the controller under the driver or passenger front seat.
The second way to get the code is using a jumper wire on the diagnostic connector located on the kick panel at the front passenger side. You then watch the codes being flashed at the dash panel after you turn the key on. To read the code being flashed is easy. Example: Code 23 is 2 long flashes followed by 3 short flashes. A longer pause separates the next code that follows.
Here are Acura vehicles 1986-95 general codes:
Code 0 Electronic control unit (ecu)
Code 1 02 (oxygen) sensor
Code 3 and 5 map sensor
Code 4 Crank angle sensor
Code 6 Coolant temperature sensor
Code 7 Throttle angle sensor
Code 8 Crank angle sensor (TDC)
Code 9 Crank angle sensor (CLY)
Code 10 Intake air temperature sensor
Code 12 EGR system fault
Code 13 Atmospheric pressure sensor
Code 14 Electronic air control valve
Code 15 Ignition output signal
Code 16 Fuel injector fault
Code 17 Vehicle speed sensor
Code 21 Spool solenoid valve
Code 22 Valve timing oil pressure switch fault
Code 23 Knock sensor
Code 41 Oxygen sensor heater fault
Code 43 Fuel supply system

Nov 30, 2010 | 1990 Acura Legend

7 Answers

95 Caravan won't start. only a single click. I


Turn the crank pulley make sure the engine is not siezed

Jul 07, 2009 | 2003 Dodge Caravan

3 Answers

95 Acura Integra starting problem


This happened to me on a 95 Integra GSR and the entire starter did not need to be replaced, just the solenoid pieces. They get old and worn down and the plunger no longer makes a good connection with them, hence the "click". Replace the solenoid panels and sand the plunger and your good as new. You can find instructions for this on the net, just do a search for it.

May 11, 2009 | 1995 Acura Integra Coupe

1 Answer

95 hundai accent wont start


The wiring diagrams for the 95 Accent do not show any OEM (original equipment manufacture) 'anti-theft' systems.... this does not preclude the possibility that an After Market system was installed.

Mar 26, 2009 | Hyundai Motor 2003 Elantra

1 Answer

Intermittant no start nissan almera 1800 sport +


hi you need someone to pinpoint where the click is coming from as for the air escaping there is no air involved in starting any cars so a faint clicking is its a bad contact usually a relay but on most cars are not under the bonnet which makes me think a loose connection are the ignition lights still bright when you are trying to turn it over or do the lights go dim or nearly out if so also check your battery leads for tightness and earth leads yates210456

Oct 09, 2008 | 2005 Nissan Altima

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...