1 Look at the belt routing (the way the belt runs around all of the pulleys). If you do not find a belt routing diagram under the hood, you'll want to make your own sketch.
2 Find the belt tensioner pulley, usually located just above the crankshaft.
3 Insert your 19mm ratchet or breaker bar tool into the tensioner bolt head and pull toward the front of the vehicle to release tension on the belt.
4 Slip the old belt off of the pulleys.
5 Reference your belt routing diagram to get the new belt seated on all pulleys. Make sure any grooves on the belt rest against grooved pulleys, and that smooth belt surfaces contact smooth pulleys.
6 Slowly release the tensioner and check for correct belt tension.
7 Run the engine and observe for flapping or noise, signs of incorrect installation.
Regards,
Tony
SOURCE: need belt schematic for 2006 toyota corolla
I can get you a diagram on monday but it goes from the alternator to the power steering pump then around the tensioner pulley then around the crank pulley then to the a/c compressor then pull on the tensioner to give you some slack and slip it on the waterpump.I hope that helps.Let me know if you still need the diagram
SOURCE: Need a serpentine belt diagram for 2004 Toyota
Sorry for the delayed response.
CLICK on the following LINK. It has the Serpentine Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
Thanks.
http://www.2carpros.com/car_repair_information/year/2004/make/toyota/model/corolla/2004_toyota_corolla_drive_belt_routing_diagram.htm
SOURCE: need toyota corolla 2002 serpentine belt diagram
I assume you have the 1.8 liter engine. If not, please get back to me.
SOURCE: I need a serpentine belt diagram for 2007 Toyota
Below is a link to a diagram. The TP is the tensioner pulley.
http://www.chiltonlibrary.com/content/images/7923/images/79234g54.gif
15,697 views
Usually answered in minutes!
×