Question about 1995 Honda Civic
This is usually related to the main relay. its a common problem with hondas of this year. the main relay is located the dash.
this is a link on how to locate the main relay. usually its around 50 dollars at autozone. hope this helps. goodluck
Posted on Jun 11, 2011
check your battery, and see if the cca's (cold crankink amps) are up to par. How to test is, when it is cold try starting, if it starts slow shut off immediatly and put a "jump" on it. If it starts quickly...replace battery.
Posted on Oct 31, 2009
I've owned the same car. Check that the fuel relay 'primes' the system before you start the car. When you turn the key to the on position (all you dash lights, ready to start) you should hear the fuel pump run for a second or two. If it doesn't run you can replace the relay for about $30. If the relay is not the problem, it may be a check valve within the fuel line to the engine. This valve keeps fuel from draining back to the tank when the car is sitting. That way, there is fuel close to the motor when it's time to start. The temp senor was not a bad shot, they were thinking it was bad sensor not telling the cold start injector to run. Obviously not the case. However, the injector itself may be faulty in some way. As long as the car always starts, it's one of these problems, assuming the ignition system and engine mechanicals are in running order. good luck. JK
Posted on Jul 05, 2008
Tips for a great answer:
May 31, 2018 | Cars & Trucks
Jun 16, 2016 | Kia Cars & Trucks
Aug 20, 2017 | GMC Savana Cars & Trucks
Nov 23, 2013 | 2004 Renault Megane 1.9
Mar 18, 2017 | Cars & Trucks
Jul 13, 2012 | Cars & Trucks
Jun 08, 2012 | Honda Cars & Trucks
Welcome to FIxYa.com
Cranks but no start or tries to start hot? Check ignition module when hot the board expands and cold contracts.
Regards, Lee Davidian
Thank you for using FixYa,com.
Oct 23, 2010 | 2000 Kia Sportage
Oct 28, 2009 | Cars & Trucks
Dec 18, 2008 | 1992 Pontiac Grand Am
622 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: