2004 BMW 5 Series Logo

Related Topics:

tamas zoltan Posted on Jun 07, 2011

The next problem. error of the DSC and the Active Steering is 5ec1 ce96 614a ce9c. does not work with power and light up the show so much dsc.a testers. Thank you

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Oct 29, 2008

SOURCE: 2004 BMW 525i Active Steering problem

The Active Steering system uses a Papst brushless dc motor to rotate the cage (ring gear) containing the planet gears a planetary gearbox at the bottom of the steering column. The motor effectively changes the steering ratio by increasing or decreasing the amount of gearbox output rotation relative to changes in the steering-wheel angle input. The resulting ratio depends on the speed of the car. For instance, a low 10:1 ratio gives high maneuverability for parking in tight spaces, with less than two turns of the steering wheel, lock to lock. To track straight at highway speeds, where even a small steering input can produce a quick sideways acceleration, the electric drive boosts the ratio to 20:1. Cars without Active Steering typically have ratios halfway between (specifically 14.1:1 for the BMW).
....
Now, if your active steering does not work , the car reverses back to power steering and the ratio is 15.1:1 so the car can be driven but the "active steering " is not working and still needs to be fixed.
It the unit needs to be replaced and your car is not under warranty, the repair cost may reach 5000 dollars.

Ad

Anonymous

  • 318 Answers
  • Posted on Jun 07, 2009

SOURCE: Yellow DSC and Brake light on... recently changed brake pads

Abs and dsc are related and with the light on these won't work. It is possible that you need to go back to where the work was done to look this over.

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Jul 13, 2010

SOURCE: DSC faulty

check the brake fluid level

steve_e_uk

steve morris

  • 1675 Answers
  • Posted on Oct 17, 2011

SOURCE: I have a 2005 BMW x5 as soon I start driving, my

Hi This sounds like a DSC fault more than anything, have you any fault codes? have you fitted anything new to your vehicle recently that is made by someone other than BMW?, you could try unplugging the DSC unit and having a look at the plug for corrosion on the contacts, ( this is the same as ABS module located on left hand side near head light on normal car under bonnet/hood should be same for yours) also you can have a look at the throttle body connector for same thing corrosion on the contacts, just clean and see how that goes, but check to see if you have error codes in the ECU/ECM just something for you to look at please contact me for anything else...good luck

Anonymous

  • 1 Answer
  • Posted on Dec 03, 2012

SOURCE: 2000 328i BMW DSC light

DSC light only comes on.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

DSC comes on at highway speeds on dry pavement. Cruise disengages. Have to manually override with DTC button or it will slow the car to stop.

ABC/ASC/DSC lights on due to bad tires/wheel not centered ...

www.bimmerforums.com/forum/showthread.php?1568281...DSC...
Dec 5, 2010 - Thread: ABC/ASC/DSC lights on due to bad tires/wheel not centered? ... I was driving at highway speeds again. I drove the car for 10 mins, then ..... I cleared them. If the lights come back on, I'll scan with INPA and see what it reports. .... This was happening at low speeds on dry pavement. So something is ... Dsc - Bimmerforums
Feb 14, 2012
DSC blinking more sensitive since new tires - Bimmerforums
Oct 18, 2010
DSC is awesome...
May 1, 2004
More results from www.bimmerforums.com
0helpful
1answer

RX-8 & DSC

Hi Melissa,

I had a similar problem with my 2005 RX8 but didn't try using the DSC button. I had to have my engine rebuilt....I'm in So Cal and found a great private mechanic, are you local???
0helpful
1answer

Will faulty dsc light cut power to engine

you're going into limp mode. If you have no compression you most likely have a bad valve and the head will need to come off and have some new valves put in.
0helpful
1answer

Mini Cooper S Engine Management Light

The following are descriptions from the Mini-Cooper S owner's manual.

Service Engine Soon "?If the warning lamp comes on
either continuously or intermittently, this indicates a malfunction in the emissions-related electronic systems."

EML light: "Engine electronics ?Malfunction in the engine electronics. You can continue to drive with reduced engine output or engine speed."

Triangle circled by an arrow: "Automatic Stability Control plus
Traction (ASC+T)/Dynamic Stability Control (DSC)
?Indicator lamp flashes: System active: drive and braking forces are regulated.
The indicator lamp stays lit: ASC+T/DSC switched off with button or defective. In the event of a defect: please have the system inspected at your MINI Dealer."

First, inspect the belts to make sure none failed at high RPM. If one broke, inspect any cable or hoses in the plane of the belt to see if there was any damage (e. g., a ripped wire in the ASC+T/DSC system). Second, get a readout of the engine error code. (If you get indications of a major vacuum leak including rough idle, look for a blown head gasket.) If you get something else, please post the results in a comment so we can go to the next step.
1helpful
3answers

I have a 2005 BMW x5 as soon I start driving, my abs light, my brake light and my 4 by 4 light are on and also the dsc is not active

Hi This sounds like a DSC fault more than anything, have you any fault codes? have you fitted anything new to your vehicle recently that is made by someone other than BMW?, you could try unplugging the DSC unit and having a look at the plug for corrosion on the contacts, ( this is the same as ABS module located on left hand side near head light on normal car under bonnet/hood should be same for yours) also you can have a look at the throttle body connector for same thing corrosion on the contacts, just clean and see how that goes, but check to see if you have error codes in the ECU/ECM just something for you to look at please contact me for anything else...good luck
Oct 13, 2011 • 2005 BMW X5
0helpful
1answer

Yellow brake lights and DSC lights are on at the same time on the dash. What does that mean?

The yellow light and DSC light is to warn the driver the traction control and DSC is set to OFF.

Put the car to park and take the key out should reset it back to normal mode. DSC = ON and TC = ON.

Is it possible someone hold the DSC selector down and disable the TC and DSC?


If my answer is useful then place rate it.

Thanks

MUSTGO




0helpful
1answer

Yellow DSC and Brake light on... recently changed brake pads

Abs and dsc are related and with the light on these won't work. It is possible that you need to go back to where the work was done to look this over.
0helpful
1answer

Jaguar S type DSC light always on

not sure on this one but my favourite saying applies ,if it runs ok leave well alone ,to sort this out ask the jaguar dealer as its product knowledge here that will save you money in the long run .Might just need reprogrammg
0helpful
1answer

DSC and ABS lights on

It is most likely a faulty sensor, you will need to scan it with diagnostic tool to help find problem
0helpful
2answers

RESET LIGHTS

if all three lights came on at once there is definety an issue with the dynamic stability control (DSC). my first thought was steering angle sensor, but it could be many things such as DSC control unit, wheel speed sensor, or even the brake fluid low
Oct 13, 2008 • 2003 BMW Z4
Not finding what you are looking for?

407 views

Ask a Question

Usually answered in minutes!

Top BMW Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

old marine
old marine

Level 3 Expert

2426 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...