2002 Daewoo Lanos Logo

Related Topics:

Posted on Aug 24, 2017

I have a tata Indica lsi petrol manual engine,i notice the car loses power when inclining ( a.c off) from a less speed of 80km at the fifth gear sometimes i have to down shift to 3rd gear for increase power and spend but i notice i end up burning more fuel,what could be responsible for this,also when i turn my a.c on,i notice the rpm drops,should it increase to compensate for power?

5 Related Answers

Anonymous

  • 68 Answers
  • Posted on Jul 15, 2008

SOURCE: Daewoo Lanos, turns over but will not start.......

dave again i just posted you so it is definately fuel related listen to see if the fuel pump turns as described in my last post if it does not you can test the relay by replacing it with a known good relay like the horn if your horn works but your fuel pump does not turn swap em see if the horn works still and if the pump now works. If the pump works and the horn does not reinstal the horn relay in its original position and replace fuel pump relay. do the same with fuel pump fuse as sometimes the fuse looks okay but is not. If you have a test light hook it to ground and make sure both metal tabs on the fuse light the light when the pump is activaed.

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 01, 2009

SOURCE: car jerks to side when shifting gears

Hi, just had this problem repaired. The lower arm bushings are bad...not the transmission. I ordered two sets from the nubira site (for the left and right sides of the car)...they are kind of like metal rings with rubber inside...this rubber dampens the shifting from the transmission. $250 - $300 job. Sure that's what it is...

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Aug 24, 2009

SOURCE: Lost Over-drive????

time to consider a visit to the junk yard and fit a manual

Anonymous

  • 4793 Answers
  • Posted on Jul 02, 2010

SOURCE: engine is not ticking over at the correct RPM

first try using redexe fuel additive (a full bottle to 5gallons)to clean injectors/fuel pump.
your car has a fuel cutoff valve,saves fuel when coasting(over 1800 revs,if you put car in nuetral going down hill you use fuel,so you are wasting fuel in neutral.but you have read the handbook cos it tells you in there.......

Anonymous

  • 1 Answer
  • Posted on Feb 26, 2011

SOURCE: I am Asbar javaid, i am using daewoo racer model

check thier fuel pump i have also these problem change the pump and fuel injector with jenuine parts than it will be solve and rpm about 2.5

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

2009 Tata Indica LSi. What is the Tata Indica cylinder head torque settings please?

Question edited for clarity, 'year make model' first 3 words.
Question moved to model category.

Already answered on Fixya and also on Just Answer.

https://www.google.com/search?q=tata+indica+1.4+lsi+cylinder+head+torque+settings

..
0helpful
2answers

Where do i find the iac valve for my tata indica

In order to find the IAC valve for your TATA car, then you can just visit your nearest authorized Tata cars dealer or you can check the link which I have provided in the answer to buy the iac valve of the Tata Indica 1.4 LSI, Take a look



tata indica iac valve-xkkmkwjgvxgo2r24ut2sau5v-2-0.jpg
1helpful
2answers

Engine specs mains big ends and cylinder head please

On your Tata iindica LSi the main bearing torque is 60Nm, the big ends are 55Nm and the head bolts are torqued in three stages of 30Nm then 50Nm then finally 75Nm.
4helpful
2answers

Tata indica Timing marks

On. An Indica petroll or diesel there aren't aany timing marks as to say, firstly remove cylinder head, then attach a power bar or ratchet with socket to to bolt on crank shaft pulley. Rotate the engine anti-clockwise until piston one is at TDC (highest point it can go). Then at Te front of engine halfway down the block where engine meets bell housing there is a hole to. Insert a 8mm long bolt, this will lock the crankshaft. On the head on the cam shaft end cap is a hole, insert a screwdriver to fit and rotate cam with. A ratchet until the screwdriver slots in place and the cam cannot move. Replace the head, torque the bolts, fit the timing belt and tension it. Once this is done remove the locking bolt and screwdriver, Replace the cam-tappet. Cover and start the engine
0helpful
1answer

I need a wiring diagram fot tata Indica 1.4 petrol lsi

Did you ever find a wiring diagram for the tata indica 1.4 petrol lsi? I am looking for the diagram as well!
Not finding what you are looking for?

122 views

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...