SOURCE: HOW TO REMOVE THE REAR BRAKE LIGHT LENS TO REPLACE THE BULB
how do i remove my tail light assembly out of my 2005 nissan maxima
SOURCE: my 1996 nissan maxima bose system resets its self
you need to pull the radio out and verify that you have 12 volts all the time at the Pink/Blue wire in the radio connector plug, this is the keep alive memory, without this constant 12 volts the radio will reset every time the key is turned off. I assume you have checked the fuses. If the wire is ok and has 12 volts present then the radio is defective and will need to be sent out for repair..
SOURCE: headlight adjustment
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
SOURCE: I can't change a headlight in a Nissan Maxima 2007
Do you wanna to replace the complete headlamp assembly or just a burned bulb?
Dan
SOURCE: 2000 Nissan Maxima. Headlights work but tail lights won't.
your dimmer switch is the proublem it is loose or just worn they wear even if you dont ever use the switch a common nissian proublem iv had the same issue
90 views
Usually answered in minutes!
×