I checked autozone and they shows what it looks like there click on link below at :
http://www.autozone.com/autozone/parts/1999-Dodge-Intrepid/Crankshaft-Position-Sensor/_/N-jddxyZ8znbj?filterByKeyWord=crankshaft+sensor&fromString=search
SOURCE: where is the crankshaft sensor located on the
On the V6 and V8 engines, the crankshaft position sensor is bolted to the cylinder block near the rear of the right cylinder head.
Testimonial: "great thanks to info i found it now that i had right area just took a little coaxing got it out and replaced it thanks again"
SOURCE: location of speed sensor a for 99 dodge intrepid
The "Vehicle Speed Sensor" signal is generated by the transmisson output speed sensor. That is the one located at the rear of the case. It is externally mounted. That supplies "vehicle speed" info to the other On-Board Computers. The input turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info and it is located on the bell housing near the engine block. I hope this helps.
SOURCE: location of the camshaft and crankshaft sensors
cam sensor is on the driver side, front of the motor, just below the valve covers in easy veiw, just outboard of the water temp sensor and they both share the same wiring harness. The cam sensor is on the passenger side, actually on the transmission bell housing. It takes the signal from the flywheel next to the ring gear, about an inch from the engine on the transmission bellhousing. Accesible from the top and easier if you remove the air filter duct. Or jack up the front passenger side and easier if you come in from the front and its behind the axel, behind the motor, go up the bell housing, just below crank shaft level. Go with this first , it tells the comp when to send fuel. If you're getting spark with a 1381 code and you're choosing between CAM & CRANK, start with this, this is the culprit. Consider getting it from the dealer. Good luck. This is Waverunner70, Hope I could help.
SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?
it is located on the right side of the motor, in the trans area. Actually in the bell housing.
670 views
Usually answered in minutes!
×