The procedure for removing and installing turn signal light bulbs is the same as that for brake light and taillight bulbs. Only the procedure for brake light and taillight bulbs is described here.
Before servicing the vehicle, refer to the Precautions Section.
Disconnect the battery.
Switch off all electrical connectors.
Turn off ignition.
Remove the rear light, as follows:
Remove the rear striker mount cover.
Reach behind the respective quarter panel trim and unscrew the knurled nut. Make sure the washer and spacer do not fall down.
Remove the rear light and disconnect the electrical connector.
Turn the bulb holder in the direction shown and remove from the housing
Turn the bulb holder in the direction shown
Remove the bulb from holder.
Install the bulb in the reverse order of removal. When installing, make sure bulb holder engages in housing by turning in opposite direction.
Install the rear light, as follows:
Connect the electrical connector.
Insert the rear light housing into the body opening.
Insert the retaining bolt into the body opening.
Insert the rear light into the cutout.
Insert the rear light into the cutout in the direction of arrow
Slide the spacer and washer onto the retaining bolt, attach the knurled nut and tighten by hand.
Turn the bulb holder in the direction shown and remove from housing.
preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i];
ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 31;
ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog'];
ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC';
ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data';
var _strTreeScrollHidName = 'ctl00_hidTreeScrollPos';