Drivers door automatic door lock will not work

you may have a bad actuator. The driver's side one controls all the other doors. These actuators were/are a problem on the 2007-9 CRV.s

For heavy machinery cars etc. luckily there are many websites
that can help you repair
for eg site like reliable-store is very active in this.. instant help, emails and all that's fantastic

Pop off the door panels & remove the plastic film. There's a white plastic actuator attached to the lock. You can test for voltage from the connector, but unlikely that's the problem. My symptom was the actuator was moving but not actually locking. It turned out mine was loose and I fixed mine by just reattaching the actuator. There's several screws holding it in there and mine came loose. Use lock-tite because it came loose a second time. If the motor isn't functioning then if you disassemble the actuator you might be able to search on EBay for a motor - the rear tailgate uses a Mabuchi. Otherwise you will need to replace the actuator. The rear one is about $80 online.

See this:

Honda Power Door Lock Diagnosis Actuator or Passenger Multiplex Computer

How to replace Honda Odyssey sliding door lock actuator

Personally, "I" would access the Latch Actuator and unsnap the electrical connector.

Next use a OHMMETER to test if the COIL inside the body to assure it's good!

100% OPEN = BAD
6 OHMS (or so) =OK!

Honda Odyssey 2000 power door problems

Anthony!

Has Honda had a look at it? Beside the engine control module
I believe there is a body control module with relays, etc for
functions like door locks, windows, wipers, so it can get
complicated. Best bet is let Honda deal with it.

this is caused by a defective power door lock motor

When the door locks make a buzzing sound this means the lock actuator for that door is bad and will need to be replaced. If the locks do not work at each door and only from the drivers switch. Then either the lock-out on the drivers switch is on or the drivers switch is staying in lock-out. The other possibility could be that the lock actuator for the other door is bad.

YES I HAD THE SAME PROBLEM I FIXED IT BY REMOVING DRIVERS DOOR PANEL AND FOUND ACTUATOR OUT OF LINE AND WIRE CONECTORS WERE BROKE I COULD NOT FIND REPLACEMENTS SO I USED WIRE ROPE GRIPS I ALSO FOUND LOOSE CONECTIONS IN WIRING I GOT CENTREL LOOKING WORKING AGAIN, HOPE THIS IS HELP.

More than likely an actuator...just replced the one in my pathfinder. Easy to remove and replace.....check your fuses first though. If you have a bad actuator and need help on the procedures, just reply to this post and I will get a notification through my email. Swap the actuator with one from the drivers door. You should know if you actuator is bad. Another thing it might be also is that there is a little plastic "pin" that pops the lock up. If it is broken off, you need to replace the little piece. Take a look at it and you will see what I mean.

Greg

this is your power lock actuators. both quit working at same time??