2004 Audi A4 1.8 T

Reset oil service light Honda Pilot. From years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012.
How do you reset oil service light Honda Pilot. From years: 2003, 2004, 2005.

1. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).
2. Hold the button for at least 10 seconds, until the indicator resets.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset oil service light Honda Pilot. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012.
Resetting the Engine Oil Life Display if maintenance service is done by someone other than your dealer, reset the maintenance minder as
follows:

1. Turn the ignition switch to the ON (II) position.
2. Press the select/reset knob repeatedly until the engine oil life is displayed.
3. Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.
4. Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to 100.

All information is taken from the Honda Pilot owners manual.

You can find the oil life monitor reset procedure here

Oil Change Light Reset Audi Q7 2007 2008 2009 2010 Reset Your Oil Change...

You can find the oil life monitor reset procedure here
Oil Change Light Reset BMW 330xi 2001 2002 2003 2004 2005 Reset Your Oil...

fuse problem

1. Turn off the ignition
2. Press and hold the button on the left side of the display while turning the ignition on
3. Service OIL will be displayed
4. Pull out the button on the right side of the display until the service prompt is cleared
5. The display should now read ---
6. If the above procedure does not work, outlined below is an alternative procedure:
7. With the ignition off, push the right button
8. Turn the ignition on and then pull the left button
9. This should clear the warning message --- I have a 2002 A4 Quattro. To reset that Service message, hold down the service button. That's the one with the picture of a wrench on it. While holding it down, turn on the ignition. Let go of the service button and press the "Mode" button just to the right of the service button. It should clear the display.

* This does not work in older models, like my Audi A4 /1.6, 1995. It needs the cable and the program ( e.g. VAG-COM). Even with this, clearing the code (IN1 or IN2) is quite complicated.

Hi my name is mike ! on your vehicle the change oil light has to be reset by a scanner with european software ,it will have to be done at a shop ,most every audi that we work on at the shop I work at has to be done this way ,hope this has helped you !

Turn off the ignition press and hold the button on the leftside of the display while turning the ignition on it should say service oil on the display pull out the button on the rightside of the display until the service oil clears

2800.00 for an oil pump? Sounds expensive. Is it only for the pump or is other work involved? There are hoses that deteriorate that have to be replaced and an engine flush that usually goes with that repair. Also your engine may have to be replaced if there is bearing damage to the camshafts or crankshaft. This is a common problem with 1.8T's. You are not the original owner,so are you repairing the car from the selling dealer? It make a difference when your trying to get assistance. You also must have proof that all services were completed, preferably by a dealer. If you have all that and still only offer half take it and be happy!

I’m happy to help further over the phone at https://www.6ya.com/expert/anthony_dda4e0152e94f3c0

not sure if this link will help you out but have a look.. instructions on how to change the engine oil on 2004 Audi A4 3 0 Google...

get your oil pump checked with audi, i didnt, cost me £4000.00 instead of £350.00