Turn signals not working. If the hazards work but not the blinkers does that mean the flasher is ok?

How do I know if my flasher relay is bad?

Symptom of a bad or failing turn signal / hazard flasher is hazards or turn signal lights that do not function. If the flasher breaks or has any internal issues it can cause the lights to malfunction, or not respond at all when the turn signal lever or hazard light button are pressed.
Jan 19, 2016

Symptoms of a Bad or Failing Hazard / Turn Signal Flasher - YourMechanic

For the cost involved, I would change it.

https://www.fixya.com/cars/t24552531-flasher_turn_signal_located

https://www.google.com/search?q=2011+kia+sorento+flasher+relay

..

exposition ? Do you mean expedition ? What year ? The turn signal switch could be bad , bad fuse , turn signal flasher would be a likely culprit . hazard light flasher is different from turn signal flasher .

there are two flashers one for turning,one for the blinkers,and fuses to each, recheck them 4 totals

Have you checked the signal light flasher?
You have one for the hazard flashers and one for the turn signals.
Try the hazard flashers.
If they work....switch that flasher with the signal flasher....(they should be interchangeable).
Follow the clicking sound to find the hazard (working ) flasher.
(It just pulls out )
To find the non working signal light flasher....just look for another flasher under the dash that looks very much like the hazard flasher.
Now try the signal lights again with the different flasher installed....do they work now?

You did try switching flashers to see if any difference right? There's 2 in fuse panel, 1 for hazard & one for signals.

There are 2 seperate flashers 1 for turn signals and 1 for hazard.The hazard flasher is located in the convenance center the turn flasher in the fuse box. Also seperate fuse's for each. One battery circuit for hazard Ignition for turn signals.Check fuse for hazard,if good try swapping in the turn signal flasher and see if hazards work.They use the same flasher unit.

Try replacing the Flasher first before spending to much money for a possible simple fix. If it's not your flasher then it could be the turn signal leaver.
Ok, this may seem stupid, but that's what they did to the blazer. They set the flasher near the middle and under the center console behind the radio.

It's to the left of the radio right behind the dash. The hazard flasher and the turn signal flasher are side by side.  It right next to the Cig lighter behind the panel. They do mark the turn signal from the hazard flasher on the plastic behind them. Turn is on the right.

Good luck and hope this helps.

Do u mean the hazard flashers work, but not the turn signals? If so, check the turn signal flasher, it should be replaced. If I didn't understand your question, let me know.

There are two thermal flashers one for the Hazard Warning Lights and one for the Turn signal lights. It could be the flasher for the turn signals.

The turn signals don't work, but the emergency flashers do? If that's the case, replace the flasher, you have 2 flashers, one for emergency (hazard) flasher, and one for the turn signals. It should be on the fuse block under the dash.