Question about 1988 Ford Mustang

1 Answer

Digital clock I have a digital clock from a 98 mustang that I am installing custom in another vehicle.Does anyone know where I can get a plug for the back of this or know the main power connecting posts to run the clock? There are 8 electrical posts on the plug,Need female plug. Thanks

Posted by Terlisner on


1 Answer


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Ford Master
  • 85,239 Answers

Here is a wiring diagram of the radio by wire color:

Radio Constant 12V+ Wire: Green/Yellow
Radio Switched 12V+ Wire: Yellow/Black
Radio Ground Wire: Black/Green
Radio Illumination Wire: Light Blue/Red
Radio Dimmer Wire: n/a
Radio Antenna Trigger Wire: Blue
Radio Amp Trigger Wire: Blue (Same as Antenna Trigger)
Front Speakers Size and Location: 5′ x 7′ Doors
Left Front Speaker Wire (+): Orange/Light Green
Left Front Speaker Wire (-): Light Blue/White
Right Front Speaker Wire (+): White/Light Green
Right Front Speaker Wire (-): Dark Green/Orange
Rear Speakers SIze and Location: 5′ x 7′ Rear Deck
Left Rear Speaker Wire (+): Gray/Light Blue
Left Rear Speaker Wire (-): Tan/Yellow
Right Rear Speaker Wire (+): Orange/Red
Right Rear Speaker Wire (-): Brown/Pink

Posted on Oct 21, 2008


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to replace a starter on 98 mustang

Start by unhooking your battery. Remove the 2 bolts that hold the starter to the engine block. Remove the 2 wires that are attached to the starter solenoid. Then remove the starter from the vehicle, this part is kinda tricky as there is only one way that it will come out and you have to really finagle it to work it out. then install the new one in the reverse order.

Jun 06, 2015 | 1998 Ford Mustang

1 Answer

94 mustang top went down but would not go up. checked all fuses and switch. I pulled the two trunk relays and jumped the connection while another person operated the switch and the top went up. Is the...

Without testing the electrical circuits your guess is as good as anyones . Do you know what a wiring diagram is ? How to use a DVOM - digital volt ohm meter ? To relays - lower relay & raise relay . Do you know how to test where the relay plugs in . If you look on the bottom of the relay or on the side you will see four sets of numbers , 30 - 87 & 85 - 86 . Watch this video an test the circuits . Probably just the relay , but test to be sure .
VEHICLE RELAYS Operation Diagnosis

Free wiring diagrams here Enter vehicle info. year , make , model an engine size . Under system click on body & accessories , then under subsystem click on convertible top. click the search button then the blue link .

Feb 22, 2018 | 1994 Ford Mustang

1 Answer

I need to know how to tighten up my tension pulley on a 98 mustang gt 4.6 V8???

use half inch drive + breaker bar. put the drive in the square on the tensionr and turn clock wise.

May 14, 2012 | 1998 Ford Mustang

1 Answer

What fuse is for the clock in a 1995 Ford Mustang

In lieu of sending you directly to a specific fuse, you can check them all visually (look for burns or an element that isn't connected in a U shape). Your local library probably has the Chiltons repair manual for '94-98 Mustangs that will list all of the fuses with a picture of what each one does.

Sep 28, 2011 | 1995 Ford Mustang

1 Answer

Need to know if a 91 ford mustang with a 2.3 liter engine uses 2or 3 digit codes when using a code scanner to diagnosis engine problems

3 digits. follow this link for more info. Good Luck.

Sep 19, 2010 | 1991 Ford Mustang

2 Answers

Just bought a nice used '92 Buick LeSabre Limited. NO Owner's Manual! I can't figure out how to set the damn CLOCK! Anyone care to fill me in on this??

Turn on the power knob for the radio/clock. Wait until the clock display shows up. Press "set" button and use the 'Scan' and 'Seek' buttons to set the time.

Good Luck

Oct 09, 2009 | 1992 Buick LeSabre

1 Answer

The plug is different then the wires ,

should be the same if your talking about the coil on plug.

Aug 14, 2009 | 1998 Ford Mustang

1 Answer


fuel pump, regulator and filter need replacement.

Apr 11, 2009 | 1998 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

300 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides