Question about GMC R3500

1 Answer

2002 Workhorse chassis RV hazard flasher doesn't work

Hazard flasher bad on initial delivery. Entire turnsignal/hazard flasher switch replaced in first year. Intermittent since and quit in last year. Uses 552 bi-metal unit.

Posted by ladyjean on

  • 3 more comments 
  • ladyjean Aug 15, 2008

    Go to and you will find dealers/service centers. -LadyJean

  • ladyjean Aug 31, 2008

    8-31-08 Have found that problem is in the actual top of column switch (on-off). Somehow we have now gotten two bad switch in 5 years! Anyone else have same problem?? ladyjean

  • Anonymous May 04, 2009

    2001 workhorse chassis has no main brake lights and the cruise control stopped working at the same time. The cruise would quit on rough roads and all brake lights worked. The thing is the (HMSL) high mount stop lamp works now but none of the others, the bulbs and fuses are good. my thought is the multi-function turn signal switch is bad, but the cruise problem should not be affected by that switch, since cruise switch and wipers are on the end of the turn signal lever. My flashers and turn signals are working.  

  • Anonymous Mar 14, 2014

    no turnsignals but wipers still work and replaced flasher and nothing

  • Anonymous Mar 20, 2014

    I have checked the fuse-good, there is power to the flasher and the flasher is good. I don't know what else to check.



1 Answer


  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I am looking for a locking gas cap for my 2005 Bounder 36Z. This motorhome has a Workhorse chassis. Can you help me locate the part number and a dealer near Newberg, Oregon?

Thank you.

Sharon Bladow
503 554-1281

Posted on Aug 15, 2008


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the flasher hazard on infiniti q45 1997 turnsignal and hazards stoped working cant find where to put new black square 12v fuse in at

The "new black square 12v fuse" probably is a replacement combination flasher unit. You can trace the GRN/RED and BLU/BLK wires from the hazard switch to find where the flasher is located.

Mar 03, 2015 | Infiniti Cars & Trucks

4 Answers

Turn signal lights don't work

The first place to start are fuses, check your owners manual for location, typically left side of dash.

The emergency (hazard) flashers and turn signals are on separate fuses and run through the hazard switch. If all the lights work when the hazard switch is on then the problem will likely be a blown turn signal fuse.

Other possibilities are the hazard switch itself is bad, the turn signal switch is bad or a broken wire, all of which require a meter (or test light) wiring diagram and knowledge of the circuit to test it - better to have it done.

Robert Grove
Mobile Mechanic Malibu 310 651 8020 Auto Truck RV Mobile Repair...

Aug 09, 2014 | 2002 Chevrolet Impala

1 Answer

Indicator and hazard not working in clio

CHECK THE FUSE BOX FOR blown flasher fuse. Dont think thats it but its 1st step. I think it is a bad flasher switch, if its not the fuse. Replace the switch. mike

Jun 21, 2014 | 2002 Renault Clio

1 Answer

Gmc turn signals

try removing the hazard switch this will allow turnsignal to work then see if the hazard switch was just stuck or needs replacing

Mar 30, 2014 | 2001 GMC Safari

1 Answer

2000 chevy cavalier hazard flashers wOrk turnsignals either blink once or twice or not at all replaced switch assembly nO difference both right and left same problem headlight and high beam switches work...

I believe in your car there are two flasher relays. one for the hazard and one for the turn. the turn is mounted on the steering column, up by the fire wall. Newer models have them both in one relay. and one side can go bad

Aug 17, 2011 | Chevrolet Cavalier Cars & Trucks

1 Answer

Signal lights and hazard wont work on my 2002 impala

Hello, this is almost always a bad hazard flasher. the flasher is part of the hazard switch on the dash. sometimes you can push in and out on the hazard switch several times to get them the lights to work. usually replacing the switch will take care of your problem. here is a picture of the switch that is the problem.


May 29, 2011 | Chevrolet Impala Cars & Trucks

2 Answers

I have turnsignals problem on 92 buick lasabre limited i replaced flasher, all bulbs are good. if i manually move the turnsignal lever up and down the bulbs will flash also hazard lights work what else can...

When you say you replaced "flasher" I'm guessing you mean the combination turn signal flasher unit. If the hazards "flash" on the 4 way but the turn signal does not you are looking at a turn signal switch type problem. ... If 4way flashers do NOT work you need to check wiring immediately around the flasher unit mounting area.Or change Flasher unit Good Luck.

Apr 11, 2010 | 2000 Buick LeSabre

2 Answers

My back break lights are not working the inside lights stay on when car is off car says hazard ligths are on when they are not and when car is off it beeps like you left the keys in the ignition when they...

beeping maybe light on warning instead of key warning. Brake lights go through the hazard and turnsignal switch. Hazards may not be flashing due to bad flasher, but may be turned on. Most likely possibility is hazard switch contact in combination switch (hazard and turnsignal switch in one unit). Unplug the turnsignal switch at the bottom of the steering column and see if the problems go away, and you will know if that is it.

Jan 16, 2010 | 1995 Buick Riviera

1 Answer

Where is the turnsignal flasher & hazard flasher on this jeep

I believe both are located on the fuse block, driver side of steering column.

Apr 22, 2009 | 1997 Jeep Grand Cherokee

2 Answers

2002 L300 saturn

the flasher is the hazzard switch and most likely the problem.

Jan 04, 2009 | 2002 Saturn L-Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,506 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides