Question about 1995 Pontiac Bonneville

1 Answer

Ignition replacement You have to turn ingnition on all the way and IN to start. Otherwise only cylenoid clicks. Thank you for any advise Emmanuel

Posted by Manny100 on


1 Answer


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Pontiac Master
  • 85,239 Answers

Do you have tilt steering? if so the mechanism that actuates the ignition switch down low on the upper side of the steering column is damaged, you will need to pull it apart and check for damaged broken parts.

Posted on Aug 28, 2008


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


If the panel is ok and it's not dimn when you try to start than you have to check on the starter fuse, starter relay and if this are ok than on the starter motor it self there is a positive caple which comes direct from the ingnition power supply chech if its having current when you turn your keys to start position if its having than try to start the starter motor direct by bridging the caple on the solonoid and starter direct which it have to start the vehcile. If it failes than remove the startor for repair.

Sep 26, 2014 | 2000 Ford Ranger SuperCab

1 Answer

We have replaced the starter and the car still will not start. It will however start when you put a screw driver on the cylenoid (? spelling). Could this be the ignition switch? All fuses have been...

if it starts when you bridge solenoid means starter is okay
yournext check is to see are you getting power to the small wire that comes from ignition
put a metre on it and getsomeone to turn the key should get 12 volt or 24 what ever your system is
if no power there could be ignition switch or neutral switch fault good luck

Sep 10, 2011 | 1999 Oldsmobile Intrigue

1 Answer

1992 4cyl mustang starter went out so i replaced it and when i went to start it the under hood cylenoid also went bad so i replaced it now the car has no power at all to the fuse box? if i tern the key...

it can be a fow thing mybe you hock the wire up wrong ! or it could be the cylenoid is bad ! an it could be the safty switch that is in the front set floor on the pasinger side up under the panel by your feet it will be a red button . look over the plastic panel by the door nere the under the dash ! an my be the key switch my have gone out ?

May 01, 2011 | 1992 Ford Mustang

1 Answer

I have a 93 toyota corolla .MY problem is the ignition .Sometimes when i turn the key it starts the car sometimes it doesnt star.Please help thank you.

This could be due to the follwing
1. Ingnition switch malfunctioning - Replace
2. Starter solenoid swith stickey - Replace

Nov 19, 2009 | 1993 Toyota Corolla

2 Answers

My sons golf will not start, turn the ingnition

Check/clean your battery terminal connections. If your battery is good, and assuming the starter and ignition switch is good, this would be a suspected culprit.
Hope this helps... Good luck!

Oct 12, 2009 | 1995 Volkswagen Golf

1 Answer

Sometimes Will Not Start Just Clicks And Key Stuck In Ingnition

it sounds like your ignition switch, but could also be your neutral saftey switch try putting the car in nuetral and starting it and see what happens

Aug 12, 2009 | 2004 Cadillac SRX

1 Answer

1997 Honda Accord EX wont start then will start

Most of these Accords had two recalls pertaining to the ingnition switch. There is an interlock issue, and an electrical portion of the ignition switch recall. I would start by replacing the electrical portion of the ignition switch as this will most times fix this issue. The clicking noise may indicate an issue with the starter however. Would advise having a starting and charging system test at a professional repair facility to check the starter, but the ignition issue would be where i would start.

Jun 21, 2009 | 2004 Honda Accord

1 Answer

97 cavalier was running but just stopped.

Did you replace the ignition switch or the KEY AND CYLINDER?

These are the only 2 things that can make your engine turn off when you release the ignition switch after starting the engine.

I hope this helps you.

Jan 30, 2009 | 1997 Chevrolet Cavalier

Not finding what you are looking for?
1995 Pontiac Bonneville Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides