Sounds like a loose connection, positive or ground. When problem is ongoing, jump starter relay, load side, the load side is that line with arrowhead, unplug relay, use jumper wire between those two terminals on left side of diagram. The starter motor should crank. If you try that make sure tranny is in park or neutral and parking brake is set. If it cranks with jumper but won't otherwise, have to check control side of relay, right side in the picture. That top wire is voltage from ignition switch, bottom wire is ground.
SOURCE: 2001 Jeep Gand Cherokee wont start on first try
i have a jeep grandcherokee 2001 in africa. had ecu problem. sent the part to use for repaired and the part was returned and no fault is found. engine is turning but car wont still start. I now bought the crampshaft sensor and relays. can you please suggest what other problems the car might have? Is there a any main jeep dealer in senegal? West africa.
email: [email protected].
SOURCE: Chrysler 3.5 won`t rev past 2500 rpm?
remove the aircleaner intake hose and, check the intake air control flap for free movement
SOURCE: 2001 jeep grand cherokee 4.0 engine shuts off
it is possable/likely a bad ECTS (engine coolant tep. sensor), this can cause the injectors to allow to much fuel into cylinders and cause a low compression and or flooding situation, good luck, marty
SOURCE: 97' jeep cherokee laredo shakes when driving
Could be a number of things. I've seen tires, steering stablizer, pitman arms, tie rods, etc etc cause this problem. Lock the steering colum, jack up the front end, BOTH SIDES, and try to turn the tires by hand. If you can move it an inch or more, it's your steering components. If not, could be your stablizer or tires. If tires are getting bad, replace those first. (fyi, steering components are easy to do, if you choose to do it yourself. A good parts store will help you with what you need if you can determin where it's loose. Might need a friend to help find the right cause.)
SOURCE: I put my jeep in reverse and it stalls. When i put it in drive it
check your plug wires and it wouldnt urt to check the distibutor car and rotor
81 views
Usually answered in minutes!
×