Question about 1996 Mercedes-Benz C-Class

1 Answer

C200 automatic 1996

First
My car engine doesn't run smoothly in the morrning and miss fire. It was just serviced but the engine rev is fluctuating ups and down for 5 minutes

Second

the gear is not changing as it supose to do and gear not changing quick enough.

Thank you for you advice and any information

Best Regards

Essie

Posted by esfand on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 61 Answers

This is definitely not a do it yourself job,take to shop,im a benz tech and we would be here for hrs going through the possibilities and sounds like you need an tranny rebuild

Posted on Aug 12, 2008

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Misfire,stumbles,brake pedal gets like a brick!!! 2.5liter V6 mercury cougar 2000yr


I have ran in to this before as an engine performance and emmission technician.
Sounds like the problem is in the brake booster area is leaking vacuum (air) in to the engine causing a major missfire due to a lean condition. The best way to check this with the engine off and cool so you dont burn your hands. Remove the big vacum hose that goes up to the brake booster and plug the vacum port to the engine. Make sure you get a good seal on the plug and no air is sucking down when engine is running. After that start the engine and make sure it is running smoothly, apply the brakes and see if the engine remains running smoothly. 99.999% of the times the issie is with booster tht when you apply the brakes you allowing vacuum to leak in to engine.
Replace booster and hose with new, do not go to junk yard . By tge way the brake pedal will be stiff because it needs vacuum to make smooth so dont alarm your sekf while testing it.
Good luck and let me know what happens.

Jan 08, 2015 | 2000 Mercury Cougar

1 Answer

1998 sentra will not rev up after driving for 5 miles and turning off and starting up again


Probably way overdue for a service, take it to a properly qualified and licensed mechanic you know and trust.

Nov 10, 2013 | 1998 Nissan Sentra

1 Answer

Idle fluctuates on 1995 f250, sometimes dies, sometimes revs, no apparent vaccum issues, IAC with scan tool reads low voltage issue. Could this be vaccum, charging system, faulty computer? Problem is...


Engine stalls cold or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.

Nov 08, 2012 | 1995 Ford F250

1 Answer

2000 saab 95 se runs rough after engine warms up. Snaap-on scan tool says cyl 5 miss fired


Hei, the most likely is a fault ignition cassette or injector nr 5!? If you have a scope and know how to use it, is easy to see where is the fault!

Oct 02, 2012 | 2000 Saab 9-5

1 Answer

Check engine light on. Will not rev up over 2500 rpm. Fluctuates between 2000 and 2500 rpm and runs rough. Upon first start, you can rev fine and it runs smooth as long as you hold the rpms over 3000. ...


Hi, there are a lot of things that could cause this behavior, so it would help us to diagnose your problem if you could get a scan of the OBD2 connector and send us the trouble code. If you live in the US you can usually get a free scan at your local parts chain.

May 19, 2011 | 2004 Dodge Durango

2 Answers

2002 Hyundai Elantra 100k miles - 2.0l - running rough


sounds like the throtle position sensor is miss alined or the idle screw is backed off

Dec 16, 2009 | Hyundai Motor 2002 Elantra

2 Answers

Escort 1998 1.8 zetec mis firing


Hello, did you try changing your coil pack

Feb 07, 2009 | 1996 Ford Escort 4 Door

Not finding what you are looking for?
1996 Mercedes-Benz C-Class Logo

Related Topics:

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

jalal

Level 2 Expert

178 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...