- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
well the ac compressor will come on if you have it in defrost mode,if heater is blowing cold ,after you just had thermostat replace ,you could possibly have air in system.now if your heater motor is not working which is called the blower motor under dash it could be the resistor that controls it also these rigs have been known for wire harness problems at heater control unit and the blower motor connector.good luck,mike
if engine at long stand still,the engine temperature will rise about 190 degrees the cooling fan suppose to automaticaly turn on when coolant temperature sensor get hot it cause its resistance decrease causing pcm to send power to coolant fan relays and cooling fans, when you turn on AC the cooling fans suppose to turn on to cool down AC CONDENSOR, IF NOT AC WONT WORK COOLING FAN COOLS DOWN REFRIGERANT SO IT CAN RECYCLE THROUGH THE SYSTEM AGAIN.your cooling is suppose to turn on when engine at a sit still if vechicle not moving as coolant temperature rises at a set point the cooling fans will turn on cool down engine.cooling fans dont turn on when you first cold stsrt vechicle unless you have AC SWITCH ON.if cooling fans dont turn on when vechicle at a long stand still or moving along slow traffic.if coolant temperature sensor been replaced and fuses and relays okay have dealership check see if pcm driver circuit working faulty pcm will cause cooling fans not to turn on.
It all depends on whether your truck is equipped with Automatic Climate Control or Manual HVAC. You could have a broken control head assembly a broken mode door cable, a failed electronic mode door actuator, a broken mode door, or a loose or broken wire or connector.
To put it simply, your mode doors are not swithching modes - the reason for this can vary depending on which system you have.
One of 2 problems,either the system is low on freon or most likely the problem is a bad evap temp sensor. This vehicle does not use a cycling switch to cycle compressor on and off like a conventional system does but instead measures the temp at the evaporator core itself.