Question about 2002 Ford Escape

1 Answer

Altenator how do you remove an alternator on a 2002 escape

Posted by anglenn142 on

  • Anonymous Sep 01, 2008

    How do get the alternator out it is loose?



1 Answer


Sell it and buy a Honda

Posted on Aug 30, 2008


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Do you have to take the half shaft out to remove alternator on a 2002 ford escape

If you have the 3 litre engine, yes:
3.0L Engine
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    Negative battery cable Right side intermediate axle shaft Right side splash shield and retainers Drive belt Alternator electrical connectors Alternator. Torque the mounting and adjusting bolts to 35 ft. lbs. (48Nm).

    0996b43f80200f35.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Alternator mounting-3.0L engine

To install:
  1. Install or connect the following:

    Alternator. Torque the bolts to 35 ft. lbs. (48 Nm). Alternator electrical connectors Drive belt Negative battery cable

Sep 26, 2010 | 2002 Ford Escape

1 Answer


this is a very simple job,remove all upper covering and stand back and take a good look .you should see two or three bolts with nuts on then loosen and pull out,replace with new altenator,replace all bolts and replace belt get a strong pole /bar and force altenator to stretch belt once on alt tighen lossly until you are happy.With belt at a good streachyou should have only about 5/6 mm at the furtherest points or what the handboob says .adrian,,,,

Jun 28, 2010 | 2002 Ford Escape

1 Answer

Ford escape alternator in the back and in the bottom?

The alternator removal will be a challange.You need to remove a section of frame and then the axle,after that it will all fall into place,allow about 5 hrs.

Apr 14, 2010 | 2002 Ford Escape

2 Answers

2003 ford escape charging system not working

replace alternator. the voltage regulator is also built in altenator.

Nov 29, 2009 | 2003 Ford Escape

2 Answers

How do I remove alternator on a 2002 suburban

Disconnect neg battery cable, then unplug wire harness on altenator. Then remove bolts to remove. When putting back on, put altenator on first, then belt. There will be a tensioner pulley that you can pry down or pull up with breaker bar and socket to get belt back on. Try to keep belt in place as much as possible with altenator out so you won't loose track of the routing.

You can go to and register for full free online repair manual with everything you could need for this car.

Oct 23, 2009 | 2002 Chevrolet Suburban

2 Answers

Why would my battery light stay on my 2002 escape

The light indicates that the battery is receiving insufficient charge voltage from the alternator. Take the car to an autoparts store and have the alternator output checked. Most parts stores will do the test for free. Sorry for your trouble and I hope this helped. Best wishes.

Sep 24, 2009 | Mazda Tribute Cars & Trucks

1 Answer

What is involved replacing 2002 ford escape alternator - 4 cyl engine? e.g. removing other components to get to it.

Remove Serpintine belt. Disconnect ground wire. remove necessary wiring, remove retaining bolts.Remove Alternator.

Sep 14, 2009 | 2002 Ford Escape

1 Answer

How do i remove the alternator from the ford escapes 2002

Hi there,

Disconnect the negative side of the battery. Then, remove the tire. Next, you must have to remove the halfshaft -you may want to remove it complete instead of broke the metal tag- This is the easy part. This is the difficult part: The next step is dettach the alternator. It has three bolts: one in the top, two in the bottom, after remove them, you must have to unplug it. It suppose to take off the car by the halfshaft space.


Jeep Brainy

Aug 14, 2009 | 2002 Ford Escape

3 Answers

2004 Ford Escape Electrical problem

This is a problem with the alternator. Diode rectifiers and voltage regulator replacement will give this baby a 14.2 voltage output. In this 3L V6 SUV removal of the alternator requires removing the right tire, the right axis and undercovering to reach the 6G alternator. It is a 133mm rectifier with a motorcraft, The serpentine belt is better removed from the bottom. Also keep a bucket on hand to recover the oil from the transmission.

Jan 11, 2009 | 2002 Ford Escape

1 Answer

Ford escape 2004 V6 4x4 3.0L

So, dose it need a jump start every time? Have you tested your battery? Look, I'm suggestioning that your battery is messed up and your alternator is working now. Start your truck, and unhook the battery, if the engine keeps running, it's not your altenator or regulator. If it dies, then it's likely the regulator.

Sep 14, 2008 | 2004 Ford Escape

Not finding what you are looking for?
2002 Ford Escape Logo

Related Topics:

221 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides