I have a chevy venture 1998. I put freon 134a in the low valve near the radiator in the front of the van. It blows cold air in the back of the van but not in the front. Is there another valve to put freon in to make the front air work? back = middle two seats and back long seat. front= two front seats in the front. dash board air is warm.

SOURCE: Add middle seat belt to make 3 seat belts on a bench seat?

I'll begin by saying I'm surprised there isn't a 3rd belt on a bench seat, but I think you are entering dangerous territory. There is an immense amount of engineering, testing, and development involved in seat belt systems. They are anchored very securely at points that are reinforced and designed to withstand a human body being thrown against the belt, transferring the energy to the anchors of the belts. So, besides being beyond the scope of being possible to install by your average mechanic, I shudder to think of the legal angle. If u were to be involved in an accident, and someone was injured or worse in that seat wearing the added belt, the lawsuit possibilities are scary. Having said all this, check with your local dealer, maybe the Durango is set up somehow for an extra belt, but I've never heard it before.

SOURCE: 1998 BMW 328i Drivers Seat Problem

gears are probably not engaged. take the seat out, see if the motor drive gear is still within the teeth of the seat rail. if not, force it in. Easy to take out, 4 bolts and the seat comes up and out.

SOURCE: rear brakes scrubbing on 1998 chevy venture van

Removal Procedure Tools RequiredJ 38400
Caution: Keep fingers away from rear brake shoe springs to prevent fingers from being pinched between spring and shoe web or spring and backing plate.

1. Remove the brake drum. Refer to Brake Drum Replacement



Notice: Do not over stretch the adjuster spring. Damage can occur if the spring is over stretched.

2. Use the J 38400 in order remove the adjuster spring (1). Disengage the adjuster spring loop from the tab on the adjuster actuator.
2.1. Remove the loop end of the adjuster spring from the adjuster actuator. 2.2. Remove the straight end of the adjuster spring from the secondary brake shoe.



3. Use the J 38400 in order to spread the brake shoes apart.
4. Remove the adjuster.

1. Use the J 38400 in order to spread the brake shoes apart.



Important: Ensure that the adjuster (2) engages the brake shoes (4 and 5), the park brake actuator (3), and the adjuster actuator (1) properly.

2. Install the adjuster.



Notice: Do not over stretch the adjuster spring. Damage can occur if the spring is over stretched.

3. Install the adjuster spring (1).
3.1. Install the straight end of the adjuster spring into the secondary brake shoe. 3.2. Install the loop end of the adjuster spring to the adjuster actuator.
4. Install the brake drum.

SOURCE: how to remove the middle seats

look behind the seat under the rear it's a black metal rod that runs under the seat from side to side .just above this there should be a strap sticking out the back corner of the seat .pull this strap to lay the seat forward then after you lay the seat forward reach and grab the black metal bar and squeeze the two bars together the seat will release lean it forward and lift up on the seat while still squeezing the two black bars together and the seat will lift out the track

SOURCE: need to add 13-4a freon to my 2000 venture chevy van. Where is the pressure hose located?

passengers side under the hood.....by the firewall.....