2003 CRV: light is out on dash cruise control on-off switch, how to fix?

My guess is one of the following
The power not going to the cruise servo
Cable not holding
Servo failed
Switch failed

Try checking the small switch at the top of the brake pedal. There may be two one for brake lights and one for the cruise control. To ascertain what is what, pull one wire off and see if brake lights work. If not, then the other switch controls the cruise control disconnect and engage..I you have a DC test light check to see if power is on on both side of the switch with brake pedal up. If so, depress pedal and check power on the other side there should be none, if there is the switch is defective.

On these case,to troubleshoot these problem,there are solved help links.Click the link directly and refer the details to solve these problem yourself,with help of diagrams:------
Ford ranger cruise control not working?

http://technoanswers.blogspot.in/2012/02/ford-ranger-cruise-control-not-working.html

----------- Horn and Cruise control quit working?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working.html

--------

Horn and cruise control not working on Plymouth Grand Voyager?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-not-working-on.html

------------------
Horn and Cruise control quit working on 2003 Jaguar S-Type? http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working-on.html

-------------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
Cruise control stop working on 1994 Ford ranger? http://technoanswers.blogspot.in/2012/02/cruise-control-stop-working-on-1994.html

----------
Cruise control not working? http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html

--------------
1996 Ford Explorer: Cruise Control Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/1996-ford-explorer-cruise-control.html
----------
These will help.
Thanks.

Check for a broken plastic piece under the hood on the throttle control. Top, Back right of the engine. Probably will see the cruse control cable sitting there disconnected.

JUST POP SWITCH OUT AND BULB GOES INTO SWITCH USE SMALL SCREW DRIVER TO REMOVE YOU WILL HAVE TO TWIST IT COUNTERCLOCKWISE TO REMOVE, TWIST CLOCKWISE TO INSTALL.

Check the owners manual to locate the fuse diagram ,and find the fuse that controls the cruise control. Probably a blown fuse or bad diaphram.

Check the speed control deactivation switch on the master cylinder. disconnect and use a jumper wire to connect the wires together. If the cruise works it's the switch.

The lights on the steering wheel are in the switches. To fix the lights, the whole switch needs to be replaced. Same thing goes for the Tempature Controls and radio. Overall, I think it would be very expensive to replace all of the switches to get the lights working. I have the same vehicle, and almost all of the lights are out.

I think the lights behind the gage controls are replaceable, although you still have to rip out most of the dash to get to them.

I have the auto-sense wipers, so I was leaving the wipers on all the time, and the would only work when needed. The bad part I finally found out about this was that while the wiper switch is on (even though they were not wiping), it caused all of the dash lights, switch lights and rear parking light to be on. I think this alone significantly cut down on the life of the bulb.

For now, I am just living without the lights. The temperature control is very expensive (just the part alone).

You can usually find the best price for these things at http://www.rockauto.com