- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hard top folding roof? Have the codes read. I don't work on Peugeot, But I work on others. They have a ton of sensors on them. You need to know which one is acting up. Is it the sensor or a wire or module.
I have a 206 cc of production year 2002 and the following solution worked for me. My problem was that the roof would not close anymore electronically and there were continuous (and annoying) beeps when driving. Following solved my problem: 1. Followed instructions to close the roof manually. This you can normally find on your cars manual. Alternatively have a look at video above for the manual closing of the roof. 2. After successfully closing the roof manually re-position the jumpers to automatic locking position. and re-tighten the depressurization bult. 3. Open the roof normally with the electric roof-switch. (check that the net at trunk is also closed). These steps helped me reset the automatic roof mechanism.
Thanks for the opportunity to let me help. The blower control switch in your vehicle also uses a blower relay. This relay is generally located on the firewall on the passenger side near the heater fan. You can also look in you vehicle owners manual for the location of the blower relay, it may be also be located in the fuse and relay box under the hood. Generally speaking if the highest setting doesn't work on a GM vehicle it is a high blower Relay. This item is not expensive and can be purchased at most all you local Auto parts stores. If you have a Napa, Orielly's, or AutoZone these stores will also likely help you in the location if you are unable to locate this relay. Here is a general picture
The installation of this relay is either to remove from the fuse box, or if located near the heater fan housing then you will need to remove the mounting screws, remove the wiring clip, then reverse to install.
I hope that this has helped you. D.R. Wilkins
1. INITIALIZATION OF SLIDING ROOF MOTOR
(a) The sliding roof AUTO operation and the jam protection function may not operate normally if the battery
is disconnected/reconnected, replaced or recharged. Initialize the sliding roof system using the method
(1) Turn the ignition switch ON.
(2) Initialize the sliding roof by pressing and holding the TILT UP switch until the roof glass tilts upward
fully (the roof glass automatically tilts downward slightly after fully tilting upward).
(3) Release the switch.
If the battery terminal is disconnected, the moon roof control ECU may not detect the position of the roof
glass. If the sliding roof AUTO operation is still disabled even after the sliding roof drive gear has been initialized,
the hall IC may be malfunctioning. The hall IC is built into the sliding roof drive gear and detects the
roof glass position.
If the result is not as specified, replace the drive gear assy (moon roof control ECU).