Question about 1996 Jeep Cherokee Country

2 Answers

Can I use fuel Injector Cleaner in my Jeep Cherokee 1996?

Posted by nininha1 on

Ad

2 Answers

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 92 Answers

Would not advise this-keep filtrers clean-chemical in these cleaners can damage seals on injectors

Posted on Oct 04, 2008

Ad

Brainyass Rabbit

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 242 Answers

Use it to your heart's content. It's perfectly fine.

Posted on Sep 17, 2008

Ad

2 Related Answers

emissionwiz

Marvin

  • 85239 Answers

SOURCE: 1996 jeep grand cherokee blows fuses for the feul

THE FUEL PUMP IS SHORTED MOST LIKELY, IT IS NOT THAT COMMON BUT HAVE SEEN IT MORE THAN A FEW TIMES, REPLACE THE FUEL PUMP, IT IS INDSIDE THE FUEL TANK, A HECK OF A JOB ON THE GROUND.

Posted on Nov 05, 2009

Anonymous

  • 11 Answers

SOURCE: i will replce the fuse and it may last all day or one second

Sounds like there is either a wiring short somewhere between the injectors and the source. I would first trace the wire to see if there is any missing insulation or nicks. There is the possibility that some of the wiring is shorting to the body somewhere.

A bad injector can also blow the fuse. I would check the OBD codes (if you are not familiar, easiest way is to use the key trick to see if there are any indicating a fuel injector. (Key trick: turn ignition off, then cycle off-to-on (not accessory or start) 5 times and leave on on - do not start vehicle. Odometer will display codes, which can be looked up online).

Posted on Dec 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I fix a 96 jeep grand Cherokee with 4.0 has rough idle and is hesitant until it reaches operating temp. but sets no codes?


Check the condition of spark plugs, if dirty or oily could be the timing gear or timing, wouldn't show a code, if plugs are white suggests lack of fuel, also no code . ( injector cleaner and ethanol remover for the latter ). Repair shop for timing.

Sep 14, 2014 | 1996 Jeep Grand Cherokee

1 Answer

How to clean fuel injectors in a jeep grand cherokee?


The best injector cleaner is sold by NAPA, you just add it to your fuel.

May 31, 2014 | 2002 Jeep Grand Cherokee

1 Answer

Rough idling


When my Grand Cherokee was having similar rough idling problems, I replaced all the plugs and replaced all the ignition and spark plug wires. I also put in half bottle of fuel injector cleaner in gas tank (full, as recommended). I had both immediate improvement in power, smoother idling and my gas mileage went up 2mpg (approx).

Apr 04, 2014 | 1996 Jeep Grand Cherokee

1 Answer

Blowing the #5 injector


Yes it is. The injector is part of the fuel system, if it keeps blowing, yes it is fuel system related.

Dec 20, 2013 | 1996 Jeep Grand Cherokee

1 Answer

I have a 1996 jeep grand Cherokee Laredo. It started stalling at idle and now it will not start.


sounds like a fuel supply problem-change the fuel filter and run some injector cleaner through it-it also could be a bad fuel pump-Denny

Nov 02, 2013 | 1996 Jeep Grand Cherokee

1 Answer

I have to turn my 98 Jeep over 3 to 4 X before it will start. Is this to do with the fuel injectors and rail?


run a can of injector cleaner through with your next fill and replace fuel filter but do in reverse order lol fuel filter then fill tank and add injector cleaner

Sep 19, 2013 | 1999 Jeep Cherokee

1 Answer

How do I replace a fuel injector in a 1986 jeep Cherokee 2.5liter


1.) Remove air inlet elbow and hose.
2.) Remove injector wiring connector and injector retainer clip.
3.) Using small pliers, carefully grasp center collar of injector between electrical terminals and carefully remove injector with lifting-twisting motion. Discard both "O" rings.

To iInstall
Using light oil, lubricate new upper and lower "O" rings. Install them in housing bore. Install back-up ring over upper "O" ring. Position replacement injector in fuel body. Center nozzle in lower housing bore. Use pushing-twisting motion to seat injector. Align wire connectors in proper orientation. Install retainer clip and screws. Connect injector wiring. Install air cleaner.

Apr 06, 2010 | 1986 Jeep Cherokee

2 Answers

96 jeep grand cherokee starts but wont idle


CHECK FUEL REGULATOR ON FUEL INJECTOR RAIL,&ALSO FUEL PUMP, CHARLIE

Feb 21, 2010 | 1996 Jeep Grand Cherokee

1 Answer

Will not stay started unless foot on gas


i would put some STP- gas treatment with fuel injector cleaner in it may sure you have at less a half tank of gas and add a little more after putting the STP in drive the car where you can drive around 55mph or more if car gets better replace the fuel filter if you have a Shell near you use that they have a good cleaner in they gas Merry Christmas & Happy New Year as always wish you the best of luck Michigan Man

Dec 21, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1996 Jeep Cherokee Country Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...