I have to replace fuel pump, do you have a procdure to replace fuel pump in 2001 focus wagon, 2.0 split port engine. thanks.

SOHC or DOHC? - Ford Focus Forum, Ford Focus ST Forum, Ford Focus ...

www.focusfanatics.com/forum/spi...2000.../249258-sohc-dohc.html

Jan 26, 2011 - The eigth letter in the VIN is a P. If you could stop. ... SPI Performance (2000-2004) The place to chat about any 2.0L Split Port Injection engine ... What kind of engine in my 03 svt???
Mar 11, 2015
Non-interference engine or not on Ford Focus 2001 SE?
Mar 2, 2014
Do I have an interference engine?
Jul 19, 2011
2001 Focus Timing belt broke
Feb 3, 2011
More results from www.focusfanatics.com
SPI VIN 'P' Timing Belt Replacement - YouTube? 22:10www.youtube.com/watch?v=oWFVDjqPzykDec 9, 2011 - Uploaded by ZX2Fast... you how to replace/service the timing belt on a Ford SPI (CVH) engine ... how to do a water pump and timing ...ZETEC Engine Swap For SPI Ford Focus 00 01 02 0

Right now look at the front of the engine behind the exhaust manifold and their are two breather pipes connected to a T connection that comes from the engine and check these pipes as if perished and split the engine will not idle .You cannot adjust anything without a dealer software to reset the mapping so check these pipes first and iam sure you will find their split and gone soft

i have ford focus ghia 2.0 2002 model and i have problem with the fuel pump sometimes it works sometimes it doesn't.. when i fill the tank petrol pores out, the pipe next to the filter also comes out, how do i fix the problem?

Why are you looking for the fuse for the fuel pump? If the fuse is blown, it is probably due to a shorted fuel pump motor or wires. Replacing the fuse will most likely NOT fix whatever problem you are experiencing.
On the other hand, if the engine suddenly stopped running immediately after hitting a large bump or pothole, the inertia switch may need to be reset. It is located behind the right front kick panel (See picture)

Please also review this article: Where's The Fuse?

maybe fuel pump

Hope this helps.

oxygen flow meter

not sure what the sound was, but if there's a blown head gasket, the water that gets in a cylinder won't compress and it won't turn over very well and sometimes not at all. that may be what they mean by "holding compression".

check for water in the oil...it'll foam up on the dipstick,

Get a second opinion from a reputable shop other than Ford.... If it's a head gasket, it's much cheaper than an engine swap, if that's what you're thinking...

uplug air metering sensor car should run almost normal but will set check eng, light

Hi,

To my knowledge, a 2003 Ford Focus 2.0 SPi engine would need 4 quarts of engine oil (roughly 3.78 liters). Incidentally, the Ford/Cosworth Zeta/Zetec engine would be needing 4.25 quarts (~4 liters).

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.