Question about 2002 GMC Envoy

1 Answer

I cannot turn my ignition off and the key wont come out in my 2002 gmc envoy

Posted by Anonymous on


1 Answer


  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 7 Answers

It may be a transmision linkage problem. Try shiftind gears from park, N, D, 3, 2 ,1, back to park.

Posted on Apr 03, 2011


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How do i reset security system on an 05 gmc envoy

Try using the door key to lock and unlock the drivers door.

May 30, 2014 | 2005 GMC Envoy

1 Answer

Went to replace passenger side blend door actuator, (2002 GMC Envoy) but actuator is ok, shaft that goes to door only turns about 1/8 turn- needs to turn 1/4 turn. what can I do?

Try system reboot. Disconnect engine battery for two minutes, reconnect and turn the ignition key to the 'on' position and wait two minutes for the system to recalibrate actuators.

Jan 09, 2014 | 2002 GMC Envoy

1 Answer

2002 envoy key wont turn all the way off and wont start. battery is good

a lock smith can change your ignition switch at the house usually

Aug 09, 2011 | 2002 GMC Envoy

1 Answer

2002 GMC Envoy, key stuck in ignition, car won't start. Can't close sunrooF!

Replace your ignition switch, common problem, especially in 2002. As far as getting your key out:

Look under the switch that you put your key in on the bottom part of the steering column cover....In your year, some have an open hole there in which you can push the solenoid to release your key. Others have an outline of where a hole was going to go, will be very faint. But this can be carefully cut or drilled out to access the solenoid.

Apr 08, 2011 | 2002 GMC Envoy

1 Answer

I just changed the batter in a 2002 envoy and now it wont stay running if i let off the gas please help

Try resetting the ECM, turn the ignition key to the on position "engine not running" and pull the fuse to the ECM and place it back in. Leave the keys in that position for 30 seconds and then turn it off and on again for 5 seconds and start. this will reset the ECM to default. It may stall again but let it, just start it again and let idle for 3min and go foe a test drive. This should reset the way the engine and transmission performance, and should reset the idle issue on your Envoy. Good luck and keep me posted.

Jan 12, 2010 | 2002 GMC Envoy

1 Answer

Envoy is running on highway and suddently turn off & wont start

This could be a bad key. Expensive but if necassary to replace to check on the symptom of the car since no codes are being thrown. I would also say check your Idle Air Control valve and your EGR valve to make sure they are working proplery

Apr 17, 2009 | 2002 GMC Envoy

1 Answer

Key on my 2002 envoy want turn all the way back and come out ,why is this ?

I can not release the key from the ignition. I have replaced the PNP switch. If I wait ten to twenty minutes it will release it sometimes. I don't know what to do from here. Please Help!!!!

Jun 18, 2008 | 2002 GMC Envoy

4 Answers

2002 GMC Envoy

If your 2002 gmc envoy or sierra will not even turn over with a kown good battery try starting it in nuetral then go back to park and try starting again. There is a park nuetral safety switch that can malfunction. Turn the key on then shift into nuetral, then turn fully to start.

May 19, 2008 | 2002 GMC Envoy

Not finding what you are looking for?
2002 GMC Envoy Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides