2002 jeep liberty auto trans check engine lte on code p0700 and will not shift of=ver 2nd gear when goes into 3rd gear it feels like in neutral

SX 2.4L w/Auto Trans Slip/Jerk Shift Problem - Kia Forum

www.kia-forums.com/kia-forte...td.../55002-sx-2-4l-w-auto-trans.html

Nov 5, 2009 - 10 posts - ‎8 authors
A noticable rev in RPM between 2nd and 3rd gear only after startup. I had been ... Last edited by TeeJay1959; 11-05-2009 at 04:49 PM. TeeJay1959 is ... Started engine, accelerated out of parking lot and got a rude jerk between 2nd and 3rd gear. You are right .... 1 Attachment(s) 93-02 Kia Sportage Mud. 2nd to 3rd gear shift a "jolting" exoerience
10 posts
Jan 30, 2015
Please Help with 2006 Spectra Transmission
10 posts
Jan 31, 2012
2010 Surging while driving
10 posts
Jul 4, 2011
2005 Kia Spectra Auto Trans Problem
10 posts
Jun 18, 2005
More results from www.kia-forums.com

Kia Sportage Software Update - RepairPal

2005 Jeep Liberty Service Repair Workshop Manual INSTANT DOWNLOAD

get your car fix right now:))

gear, is this a Manual trans? or AUTO you said gear.
what gear, please name the gear, 1,2,3,4,5 R
or PRNDL ( a/t box auto matic) what shift lever selection?
what is out door air temp, you do know brakes can get wet and freeze right?
it wont go you meant? until brakes are touched, key word won't?

ok engine only starts in PRNDL set to N??
is that it?
and then when you shift to D, the car will not move
what about the other gears.? try them all yet?

my guess (wild) is that you dont know how park lock out works.?
that you must hold the brake pedal down to shift to park or neutral.
is that it? (read operators guide?)

my guess is car is not drive-able. key point1 (a dead car)
point 2, engine starts and runs. and races on demand with gas foot.
point 3, im lost. (no trans stated or clear symptoms.)

my jeep has 6speed manual box
and the clutch allows me to start car.
on Automatics trans must be in park or neutral to crank engine.

"it will go till i touch brakes"



I read that 10 times,
my 2nd guess. the engine stalls ?

IS THAT IT, stalls means engine RPM is 0
and right foot actions are dead.
and all dash lamps glow, telling you STALL is now.

lunges?
well is then surging,? (rpm)
or is the transmission just slipping, or shifting wrong.
only you an tell this. not us.

like a standard, you mean manual stick shift??
but you never said what trans is there. auto or stick? so?

then the problem will be in the wiring harness and connections

shift solenoid for third gear maybe bad up inside the transmission pan

IF the abs dash light is on and if the speedometer is sluggish or not working at all, it is probably a bad speed sensor on the transmission. and easy fix under $40 for the part. Mine was stuck in second gear for a while then worked then it stuck in first gear and i had the CHECK ENGINE light on.

YOU NEED TO HAVE TRANSMISSION CONTROL SYSTEM SCANNED..IT HAS DETECTED A PROBLEM IN THE ELECTRICAL SYSTEM,INTERNAL OF TRANS OR A SENSOR FOR TRANSMISSION..A TRANSMISSION IS AN EXPENSIVE COMPONENT..YOU SHOULD GET IT CHECKED ASAP..ESPECIALLY IF YOU HAVE NO WARRANTY LEFT

Ratio codes generally indicate a pressure loss & slipping which the computer reads as a gear ratio problem. Likely you need a rebuild.

replace the input speed sensor to transmission and the wiring pigtail all are available at your chrysler dealer take your vehicle registration in to the parts counter so they have your vin # to get the right part and it is the front of trans by fluid linres to radiator.