Question about 1994 Jeep Grand Cherokee

1 Answer

94 jeep won't start

I changed the battery in my jeep after i put the new one in it won't start it's like the security system has it shut down

Posted by kjjk68 on

  • divagma Jan 27, 2009

    need to know if 1994 jeep cherokee (grans) does key have security chip in it

×

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Have you tried manually unlocking the hatch to reset the security
system?? My 94 grand cherokee limited did not have a key pad to turn system on/off...i have reset it by turning the key in the rear hatch lock to the left twice...see if this works. - SmokeWrench

Posted on Aug 16, 2008

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 jeep grand Cherokee that want start. They went to put new battery in put it in backwards an killed jeep. Now want start an the alarm is goin off. Will it start if i take security system out


No it won't start if you take the security system out . Because you can't take the software out that's programmed into the PCM/ BCM ! If the PCM - engine computer does not see a key code (pass word ) It will not start the car. Besides that , hooking up the battery backwards probably did more damage then that . Fried computers etc... I have see this more then once , the vehicle's never did work right again . Damaged instrument clusters , charging systems , ignition modules etc...

Jan 12, 2017 | Jeep Cars & Trucks

1 Answer

My 2006 jeep liberty won't start. Got a new


Your problem if I got you well has more to do with the security system of your car. I suggest that U take it to qualified personel so they reset it for U. The anti-theft remain remains engaged, that's the one U need rectified.

Aug 25, 2013 | Cars & Trucks

1 Answer

My jeep grand Cherokee lorado 1998 won't start. If


are the inside of the battery terms dirty,corroided? do you know if motor alt is charging batt? how long did it run when you put new batt in? if it lasted about two days, its proubly not charging, also make sure nothing is being left on draining batt down, to check that, leave batt nuhooked pos side over night.

Feb 19, 2013 | Cars & Trucks

1 Answer

I have a 1994 jeep grand cherokee manufactured in October 1993. The problem I'm having is that the jeep wont start. At first we had no gas, no spark. We checked crankshaft sensor...it's ok, but...


Try this. Lock and unlock the tail gate with the key and see if it will start. The battery must be hooked uo when this procedure is followed. Whenever the battery is disconnected, the security circuit shuts the ignition down.
When you hook up any battery, make certain that you connect the positive battery cable first and negatvie (ground) second.

May 16, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Security lites won,t shut off have to disconnect battery


Try turning the door key in the rear door hatch lock, lock-unlock-lock. That should shut down the factory security system.

Jan 13, 2011 | 1995 Jeep Grand Cherokee

3 Answers

Jeep will start & but shuts off in a few seconds i think it may be the security system. How do I shut the system off?


I can tell you how to disable the security system, but I can't guarantee it will work again in the future... If interested, read on.
Under the rear passenger seat there is a wire harness. Look for the purple wire with the yellow tracer. Cut it and touch it to a ground point (scrape a spot down to metal somewhere nearby). This should disable the security system. If I remember correctly back to when I had the same problem with my 94 Grand, I actually crimped an electrical connector to the end of the wire and attached it to ground permanently with a screw. I had no security system, but I could drive my Jeep!

Nov 18, 2010 | 1999 Jeep Grand Cherokee

1 Answer

94 Jeep Grand Cherokee diagram panel flashes on the "miles to service" message, clock won't stay set. I suspect that at some point my husband disconnected the battery, and the system needs to be reset -...


there are two buttons on the diagram panel screen, push and hold top button and a one of the entries will start to blink, then you use the bottom button to change the entry, when you are ready to move to the next entry push the top button again.

Jul 29, 2009 | 1994 Jeep Grand Cherokee

1 Answer

93 grand ltd Stalls after intial start all dummy lights come


greetings: the reason your veh will not run is because the security system has been activated. it will allow you to start it but the security system kills the motor so the veh can not be driven off if in fact it was being stolen. if you have the remote control, lock the veh and then unlock it. this will shut the security system down and return your veh to normal and it should start and run normal. i have a 93 and 94 both worked this way. using the key to lock and unlock to shut the system did not work for me but the remote did the job.also anytime the batt cable is removed, the security system will activate when you put the batt cable back on. then you have to do what i described above on mine to deactivate the security system. the manual says use the key to deactivate the system but that does not work on mine. i hope this helps have a great day wayne

Feb 04, 2009 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
1994 Jeep Grand Cherokee Logo

Related Topics:

467 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...