On the lower left hand side of the dash, near the Traction control button, is a small push button. Just press and hold until the Tire Pressure light goes out. Of course, make sure you're pressure is ok, otherwise, it will just come back on in a couple minutes.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
definetly tire prssure low light. you can reset it by scrolling through the mileage and trip meter once you get to the screen for the tire preesure monitor hold the button down till it flashes and it will reset. make sure you check all your tire pressures first.
The tire pressure monitor detects any changes in the tire inflation
pressure. Therefore, it must initialize and store it in its memory if
the tires or wheels have been replaced, re-inflated or the tires have
been rotated. You should be able to re-initialize the system by following these
1. check and make sure that your tires are inflated to the correct pressure
2. turn the ignition switch to the ON position. If the low tire
pressure warning light comes on, push and hold the tire pressure
warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns
off and then release the switch.
3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.
4. initialization is *not* completed until driving at the vehicle speed
of 19 mph or over for more than one hour. the tire pressure monitoring
starts when initialization is completed.
that would be your low tire light, check the tire pressures and set them to whatever it says in the drivers door jamb, it will tell you the factory psi settings there. if you had the tires rotated recently that might cause the light to come on untill the tire positions are learned by the cards module. if all else fails a dealer is pretty much the only place that can diagnose tire pressure monitor problems
(!) is the tire pressure indicator. Generally means one or more tires is significantly below the set tire pressure. The indicator on my 2004 Solara comes on and goes off all the time even though the tire pressure is the same on all four tires and I have reset the indicator.
Check the pressure on your tires and if they are all at the recommended pressure turn your ignition on and hold the tire pressure reset button in until the (!) blinks 3 times. That will set the pressure. The button is on the lower part of the dash to the left of the steering wheel.
32 psiis actually low for a 3500. I have a 1500 silverado that runs 44 psi cold. The tire inflation monitor , monitors inflated cirunference. Sooooo, If it isn'nt round enough, it will let you know. Driving warms up both the air and the tire,off course changing everything again. Pressure is up and tire is bigger. Ask me not how it can tell what is going on with the tire sitting still. I'm only on page 9,000, the answer is here somewher. :-) Well good luck. I do know the above is accurate._Ned_