Replace the "Blower Motor Resistor".Check autozone or ford dealership.It is located behind the glove box to the left.Open glove box and push the sides in to lower it.Follow the electrical connector back to the resistor. There should be one screw holding it in.Good Luck!!!
SOURCE: Very low air flow through vents despite the fan working well
It is very likely that the Air conditioner evaporator core is restricted due to leaves or some other object may be blocking air flow like a plastic bag, does it do this on both outside air and recirculation setting?
SOURCE: Heat/AC Blower fan speed only works on High
Alot of people have the same problem with the fan switch and blown bulbs. There really is no fix for this. Jeep really screwed up when designing the heater control assembly. The cheapest solution is to buy another unit off Ebay. Can always go to the dealer but be ready to PAY for there mistakes.
SOURCE: 1995 GEO METRO BLOWER MOTER REPLACE
Yes, the speed control resistor is a possible culprit. There are other possibilities though. The motor itself might be wearing out. Bearings could be going bad and binding, or the motor itself could be. Usually when a speed control resistor goes, the particular speed setting that portion controls goes out completely, not just slows down. Most automotive blower motors have an independent resistor coil for each speed that you can select. If one of them goes, you lose that speed and keep the others. If you replace the resistor and continue to have a problem, you might want to remove the motor assembly completely and have it bench tested.
SOURCE: Heat/AC Blower fan speed only works on High
hello, this sounds like a bad blower motor resistor!! its cheap and easy to change..if you need more info on locations let me know,, good luck.....marty
173 views
Usually answered in minutes!
×