Question about 1994 Nissan Pickup

1 Answer

Fuel injectors won't spark on 94 nissan

Had head milled and timing chain put in. now won't start. any help is appreciated

Posted by patty88 on

Ad

1 Answer

Daniel Arellano

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

The timing may be out.The timing chain may have been installed wrong with the timing marks out of alignment with the ones on the camshaft and crankshaft.If the distributor was removed that could be it too. To time it, if the timing chain was installed right , Take off the distributor cap. Make a mark where the number one spark plug wire is. remove the number one spark plug. turn the motor manually (in nuetral) with the parking brake on.Turn the motor and install a screwdriver or other shaft inside the number one sparkplug hole. Turn until it is at the top and you can feel it with the screwdriver. turn the rotor to the mark you placed on the number one wire. replace the cap. remove the screwdriver and replace the sparkplug . Your engine should be timed now. if not check your timing belt to see if it is in alignment with the proper marks on the cam and crankshaft.

Posted on Nov 02, 2008

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2007 lincoln mkx over heated yesterday so we shut it off right away. Found water/coolant in the crank case. Wondering what a common problem in these cars is that would cause this?


It could be from a head gasket problem so have a compression test done
most times if there is no evidence of a gasket failure , the reason can be found to be corrosion holes behind the water pump impeller in the timing chain housing
these holes allow water into the sump by way of the timing chain
if that is the case the fix is a new timing chain case

Sep 28, 2015 | Lincoln Cars & Trucks

1 Answer

Timing chain guide broke on a 2007 Chevy malibu Eco tech engine 4cylinder. I've had the head reworked, new timing chain kit, head bolts, etc. I just got the head on and set the timing. Now here's my...


First, are you rotating in the correct direction? Second, remember, timing chain tension is held tight by oil pressure on the rear timing chain guide. If the engine is not running, there is nothing there to keep it tight.

Sep 20, 2014 | 2007 Chevrolet Malibu

1 Answer

92 plymouth laser rs turbo won't will crank but not start


If the cam belt broke, you need a new head.

Apr 02, 2017 | Cars & Trucks

3 Answers

JUST PUT IN A NEW STARTER . DRAINED 2, BATTERIES. WHAT SHOULD I CHECK?


I would look at replacing the battery cables,both of them,and if possible,go with larger cables,not longer,but bigger around,it will help a lot.

Apr 12, 2010 | 1985 Chevrolet Chevy

1 Answer

My 4.7 2002 dodge 1500 will not start


i purchased a new timing chain set and the cam pickup was bad on the new cam gear and we had a no start problem. i took the valve covers back off put the old gear on the cam and it started. BUT be careful if u do that you have to wedge the timing chains apart before you remove that gear so the hyd adjusters do not over expand. 4.7 dodge engines **** BIg they made them trying to save gas but the parts and repair over-ride any gas saving i got.

May 12, 2009 | 2000 Dodge Durango

1 Answer

What would cause my1999 Saturn sl1 not to start after a new head gasket was put on? Ok so today we replaced the head gasket on my 1999 Saturn Sl1 single cam. We made sure the timing chain was put back on...


Check the cam/crank sensors. Also, if the car happens to have a distributor, make sure it is not 180 degrees off. If this does not help, then do a compression check. Remember, and engine only needs three things to run. Fuel, Spark, and Compression. (in order of course.) The firing order for your engine is 1,4,3,2.

Mar 23, 2009 | 1998 Saturn SL

2 Answers

No pulse on fuel injectors


i had a friend that his nissan did the same thing he had to replace the wiring harness.

Aug 04, 2008 | 1994 Nissan Pickup

Not finding what you are looking for?
1994 Nissan Pickup Logo

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...