Cars & Trucks Logo

Related Topics:

Posted on Mar 14, 2011

Where is bluetooth module on range rover 2006

4 Related Answers

Gabriel

  • 6 Answers
  • Posted on Mar 06, 2009

SOURCE: Paired Blackberry Curve 8310 w/Range Rover 2005 drops calls

Ok, this isn't so much a solution as a work around.

As long as your phone is still holding the call (showing connected), once the Range Rover drops the call, hit the soft button that shows a picture of a green phone receiver....as if you were making a call. This will cause the Range Rover to reconnect the speakrs/mike to the phone, and you can continue your call in relative harmony.

I still haven't figured out how to get out of the jam when a second call comes in while you are still on the first....

Good Luck

prduck

Ad

gtyner

  • 280 Answers
  • Posted on Mar 17, 2010

SOURCE: 2006 Range Rover Sport heater and A/C fan do not

Check all electrical conections. If they are good then it is probably the switch itself.

Testimonial: "I'll take a look at the switch. All connections seem fine."

Anonymous

  • 1 Answer
  • Posted on Oct 01, 2010

SOURCE: Software upgrade for 2005 Range Rover Bluetooth module

Official LRNA solution: buy a new module. I will be doing this tomorrow. I have been through this comprehensively with LR Dallas and LRNA. There may well have been other modules installed depending on when the Rover was built, but mine is not flashable. BTW, when plugged in, the dealer computer checks your Rover for updated software, which is downloaded from LRNA every night.

Jonah Oneal

  • 14092 Answers
  • Posted on Oct 27, 2011

SOURCE: transmission fault traction reduce land rover

HAVE LAND ROVER OR ANY EUROPEAN DEALERSHIP CODE SCAN VECHICLE ECM AND ABS BRAKE SYSTEM SEE WHAT CAUSING TRACTION LIGHT TO FLASH ON.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Range rover 2006 sport diesel auto trans not shifting in D mode only shift in triptonic I change trans control module but its showing u3000 code now what to do?

the transmission control module has to be programmed to the vehicle using suitable diagnostic equipment. the code you have got i suspect is telling you that, all the modules on modern vehicles communicate with each other via. the can and scp networks to work correctly. if that has not been done, that is more than likely the problem, or the road speed signal may be missing but i suspect you would have other fault codes logged. hope this helps. ps. i worked for a jaguar franchise before i retired, they use the same systems, same company.
0helpful
1answer

Back up camera not working?

I have the same problem that got worse. Now the radio is not working at all after pulling the fuse to inspect it. In going around I understand that the Bluetooth module could be the culprit. I went to the dealer they told me that there is no codes for the radio.
0helpful
1answer

RANGE ROVER SS 2005 DYNAMIC RESPONSE PROBLEM

This light comes on to alert you to the fact that a fault has occurred in the system and the control module has turned it off. What must be done now is to have the system scanned by the dealer with a special tool and the fault codes read and then pin point testing done to track down the faulty part of wiring.
1helpful
1answer

What code can i use for a 2006 range rover for Bluetooth

The factory bluetooth code for all range rovers is 2121
0helpful
1answer

How to replace a 2006 range rover grill

if it's the big range rover then unscrew the upper side and then simply pull it out...if it's range rover sport then you can see clips to be released on the top and then pull it out.
3helpful
1answer

Working my bluetooth in my rangerover

easy.. start your vechile..set your phone up to search for blue tooth devices and when it find the Rover put in the code 2121
2helpful
3answers

Software upgrade for 2005 Range Rover Bluetooth module

Official LRNA solution: buy a new module. I will be doing this tomorrow. I have been through this comprehensively with LR Dallas and LRNA. There may well have been other modules installed depending on when the Rover was built, but mine is not flashable. BTW, when plugged in, the dealer computer checks your Rover for updated software, which is downloaded from LRNA every night.
0helpful
1answer

Lcd off

check you bluetooth module in left rear cargo area access panel.check connectors for bluish corrosion,also look for signs of dried water spots,possible water ingress onto entertainment modules
Not finding what you are looking for?

504 views

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...