Echo 2005 odometer reading won't reset to O - 2005 Toyota ECHO

Did you try disconnect batery for 5min.

digital odometers read into the 100k's so 999.999 , i doubt it will go to the MILLION , if it has get onto the Guiness book of Records

Hello William,

The key fobs are wearing out and need to be replaced. Sometimes taking them apart and cleaning the switch contacts and battery contacts will extend their lives but they are not built to last.

I believe your vehicles ECU sends the mileage data to the instrument panel cluster...in which the LCD odometer display has failed.

First open your ingintion and make sure dash reads odometer, then close ignition press and hold trip-odometer buttom open ignition odometer read out will show --------------- flashing lines wait until they dissapear and odometer reading is back 69487 or else then release buttom reset is done.

1. With your car OFF, place your key in the ignition and turn to "On". Do not start the car.
2. Find the odometer button and press until it reads the total odometer setting, (not the Trip A or Trip B setting).
3. Turn the key to OFF.
4. Place your finger back on the odometer button, press and hold. At the same time, turn the key back to "On".
5. Hold the odometer button in until the MAINT REQD light goes out...should take about 8-10 seconds.

page 77 of the 2004 Lexus rx330 handbook...
(you will find the answer you are looking for in resetting your maintenance light.)
with the odometer reading visible, (not trip A or trip B..) turn off engine.

While keeping Odo/trip button depressed, turn ignition back on (not starting the engine) You will see dashes (instead of numbers) on your odometer disappearing one at a time. it will be replaced by 0's (zeros).. Release the Odo/trip button and your original mileage will come up....
And your done..... until the next oil change.

Thank you for using fixya and good luck

Yes take your battery terminals off and hold them together for about 10 seconds that will reset your computer.

To reset the system. Turn the ignition key to the "OFF" position with the odometer reading shown. Turn the ignition key to the "ON" position while holding down the trip meter reset knob. Hold down the knob for at least 5 seconds. The odometer indicates "000000" and the light goes off. If the system fails to reset, the light will continue flashing.

Change the oil & filter. To reset light perform following. With instrument cluster reading odometer turn key off press & hold the reset button turn key to run position in 10 seconds should reset, If reset does not hold check owners manual there are small variances between models

first replace your fuse if the fuse burn again there is a short circuit cause of the hit search wire that is contct to the body of your car

Turn the ignition key to the "OFF" position with the odometer reading showing. Turn the ignition key to the "ON" position while holding down the trip meter reset knob. Hold it for at least 5 seconds. The odometer indicates "000000" and the light goes off.