SOURCE: '03 GMC 2500HD 4x4 problems
Take your positive cable off battery and wait a few minutes..This resets the computer and takes it out of limp mode.Theres been a lot of problems in the dash so if you can find an auto zone and have them scan it They'll do it for free.But as far as the lights my truck does the same thing. Just flick your fingers on the buttons and they should flash..The plug in the back of buttons was loose..
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
SOURCE: Truck getting too much gas
Did you check sensors such as crank senors? cam sensor? knock sensor? or mass air flow? Could all be causing it to get to much fuel. Just had same problem on 1997 Chevy Lumina
SOURCE: I had an issue with the passlock system. The
did you have the BCM programmed to the new key? the dealer has to do that.
SOURCE: passlock gmc jimmy
try this, turn key on but do not try to start, walk away for 30 mins, turn key off for 1 min, then try to start
SOURCE: 2000 GMC SONOMA GUAGE CLUSTER HAS NO POWER -TRUCK
Very good possibilty usally you can smell around column near ignition switch and it will smell burnt.
Testimonial: "THANK YOU"
66 views
Usually answered in minutes!
×