Abslight stays on no brake lights - 2000 Dodge Caravan

take to autozone and have them use a code reader to read any error codes, the do it for free and a good place to start troubleshooting

Have you recently had any work done to your vehicle, like tires or brakes? Possible a connector for the ABS wasn't re-hooked up. OR there's a short.

Check bearing connection,if you plug in right,#1 could bent pin is side,#2 broken wire check where loops wires!!!! #3 bad module.

I presume you haven't switched off the ESP or anything on the dashboard? Light might be because there is a fault with ABS, so best take to a garage and get them to read off the fault code

check your brake fluid level. most new cars have a sensor that makes the light come on when the level gets low. and on something of that vintage, that is probably a good indicator that your brakes are worn out.

this is a fairly common problem, the most obvious cause is the electrical connection to one or more of the antilock brake sensors on the brake discs ( have you been off road?), if not you have probably had a Antilock sensor failure.

The ABSlight has nothing to do with the brake pads. It comes on to tell you there is a problem with the ABS system. You best option is to have the ABS computer scanned for trouble codes. This will help narrow down the possibilities. Typical problems include bad speed sensors, bad wheel bearings, or broken exciter rings. If you had posted a Year, make, model, and engine size, I may have been able to help narrow down some possibilities and/or given some tips on what to check. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

could be, check brake fluid, if you have computer scaned you will be able to pinpoint problem, may be a sensor dirty or going bad, good luck.

Good time to inspect them, but may also be a faulty/dirty sensor.

not a good sign any leaks? if not sounds like abs mod is faulty or wiring faulty check relay that may be cycling all the time