Question about 2001 Oldsmobile Silhouette

Open Question

2001 Oldsmobile silhouette ? can the 3rd row seats in the back be switched out to a bench seat and if it can what years will fit?

Posted by tonyasaved on

Ad

5 Related Answers

autodr

autodr

  • 260 Answers

SOURCE: Olds silhouette heater blows cold air

as long as the engine temperature is normal, i would suspect a clogged heater core, the dex-cool antifreeze is notorious for building up deposits in cooling system. have heater core flushed first to see if it makes any difference

Posted on Nov 16, 2008

Ad
Tech jk

Tech jk

  • 102 Answers

SOURCE: 2001 Oldsmobile Aurora

A common cause for the heated seats to not work is a burned heater element. There is an element under the seat cushion cover, and one under the seatback cover. If either has failed, both will not work.

Posted on Dec 01, 2008

Ad

Anonymous

  • 21 Answers

SOURCE: How difficult is it to change the 02 sensor on a 2001 Oldsmobile

it is very easy you unscrew the sensor from the housing and then follow the wiring and unplug it from there.

Posted on Dec 13, 2008

Anonymous

  • 221 Answers

SOURCE: I cannot fold down seat

Try looking for a strap in your trunk it should be located at the upper inside of your trunk, there could be one or two straps, when you pull on these straps they act as a release lever for your rear seats, pull the straps toward you and push the seats forward from the trunk side.

Posted on Mar 12, 2009

Edward Jennejohn

  • 244 Answers

SOURCE: changed battery oldsmobile 2001 silhouette

a. try turning the key to accessory and leaving it there until the error light goes out. b. if you haven't yet, drive it 20-30 miles and let the main computer reset itself.
hopefully, that should solve the problem!
good luck!

Posted on Sep 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the middle bench seat on 2001 ford windstar? I already removed the 3rd row bench seat but the middle one has seatbelts attached to it and I can't figure out how to get them off the seat...


ok if you can see were they are bolt to the floor remove it from there and take the seat out with it,now if that seat is hold down by going in a slot and with a lever you pull or push to take out just do what you have to remove the seat

Jun 26, 2014 | Cars & Trucks

1 Answer

How to remove third row seats in 2001 Mitsubishi Chariot


same way as you slight the front seat forwart.lift the bar up underneed the seats

May 30, 2013 | 1998 Mercury Villager

1 Answer

How to remove rear seat in 1996 dodge ram 1500


REMOVAL & INSTALLATION
  1. Clamp the seat belts to keep them from retracting.
  2. Locate and disconnect seat wiring at the connector(s).
  3. Move front seats forward or back for access to the hold down hardware.
  4. Put the rear seats in the stowed position.
  5. On Durango 3rd row seats, lift the cushion upward and forward to floor cargo position.
  6. Remove the hardware securing the seat.
  7. On split bench models, lift the center seat upward to clear attachment stud
  8. Remove the seat from the vehicle.
NOTE Do NOT activate the track adjusters once the fastening hardware is removed.
  1. Installation is the reverse of removal.

336abe0.gif


Fig. Disconnect the wiring from under the seat

36c62e2.gif


Fig. Seat track mounting hardware locations-typical


d95c538.gif

Fig. Bench seat components: seat (1), nut (2), stud (3), floor pan (4), bolt (5)-Ram


1589e1e.gif

Fig. Split bench seat assembly-Ram


616f086.gif

Fig. Bucket seat mounting components-Durango shown


851105e.gif

Fig. Rear seat removal/installation


I hope help you with this; good luck (rated this help).

Aug 31, 2009 | 1996 Dodge Ram 1500 Club Cab

1 Answer

I NEEDED THE 2001DODEGE CARAVAN SPECIFICATION


Hi,

2001 Dodge Caravan Performance Features -3,301 cc 3.3 liters 6 V engine with 93 mm bore, 81 mm stroke, 9.3 compression ratio, overhead valve and two valves per cylinder
-Unleaded fuel
-Fuel economy EPA highway (l/100km): 9.8
-Multi-point injection fuel system
-Main 76 liter unleaded fuel tank
-Power: SAE and 134 kW , 180 HP @ 5,000 rpm; 210 ft lb , 285 Nm @ 4,000 rpm
2001 Dodge Caravan Handling & Driving Features -ABS
-Two disc brakes including two ventilated discs
-Spacesaver steel rim under body spare wheel
-Strut front suspension with stabilizer bar independent with coil springs , beam rear suspension with stabilizer bar rigid with leaf springs
2001 Dodge Caravan Exterior Features -Body side molding
-Front and rear body color bumpers
-Driver and passenger power heated black door mirrors
-External dimensions: overall length (mm): 4,803, overall width (mm): 1,996, overall height (mm): 1,750, wheelbase (mm): 2,878, front track (mm): 1,600, rear track (mm): 1,626 and curb to curb turning circle (mm): 11,460
-Complex surface lens halogen bulb headlights
-Double sliding minivan side door
-Remote control operation opening rear ¼ windows
-Metallic paint , gloss paint , pearl paint
-Fixed rear window
-Tinted glass on cabin, rear and side
-Weights: curb weight (kg) 1,842, gross trailer weight braked (kg) 907 and max legal load (kg) 772
-Windshield wipers with variable intermittent wipe
2001 Dodge Caravan Interior Features -Air conditioning with rear outlet
-Fixed mast antenna
-Manufacturer's own audio system
-Automatic drive indicator on dashboard
-Below seat storage under passenger seat
-Cargo capacity: all seats in place (liters): 433, all seats removed (liters): 4,154 and third row seats removed (liters): 1,291
-Clock
-Dashboard full console with open storage box
-Delayed/fade courtesy lights
-Cruise control
-Front seats, rear seats and 3rd row seats cup holders
-Door ajar warning
-Door pockets/bins for driver seat and passenger seat
-Floor covering: carpet in load area
-Driver and passenger front airbag
-Bucket seat
-3-point reel height adjustable front seat belts on driver seat and passenger seat
-Front seat center armrest
-Glove compartment
-Height adjustable two head restraints on front seats, rear seats and 3rd row seats
-Internal dimensions: front headroom (mm): 1,011, rear headroom (mm): 998, front hip room (mm): 1,440, rear hip room (mm): 1,722, front leg room (mm): 1,031, rear leg room (mm): 930, front shoulder room (mm): 1,588 and rear shoulder room (mm): 1,643
-Low fuel level warning
-Low washer fluid level warning
-Internal button power locks
-Power steering
-Front power windows with one one-touch
-Front reading lights
-3-point reel height adjustable rear seat belts on driver side and passenger side
-Bench one-piece two rear seats
-Rear view mirror
-Upgraded cloth/velour seat upholstery
-Seating: seven seats
-Six speakers
-Plastic steering wheel
-Tachometer
-3-point reel third row seat belts on driver side , 3-point reel third row seat belts on passenger side , lap static third row seat belts on center side
-Front facing bench removable one-piece third row seats with capacity three
-Driver and passenger vanity mirror
-Ventilation system with recirculation setting
Thanks.

Jun 18, 2009 | 2001 Dodge Caravan

2 Answers

Need a back bench seat for my 1994 Caravan


I have a third row seat available from a 1995 Caravan. Contact, [email protected]

Jun 12, 2009 | 1994 Dodge Caravan

1 Answer

Is it possible to put a 3 seater bench in second row


Yes...you can. I did this in my 05 Grand Caravan. We found ours at a local junk yard. It cost us 200 and even matched pretty well with the current benches. Just call around to your area junk/salvage people.

Mar 29, 2009 | 2005 Dodge Caravan

2 Answers

I want to make my 1999 Mercury Villager Sport into a cargo loader, with just the front seats kept and the rest of the back empty. How do I remove the other 3 seats? So far, I can't get any of them to budge...


the middle seats come out easily. There are 2 handles you have to lift up on each of the bucket seats, they are in the front of the seat down by the seat tracks. After you lift them, tilt the seat upward in the front and rotate them backward. Then lift out of the hooks. Each seat is held down by 4 hoks.

The 3rd row seat is not designed to come out xcept by a technician. It does slide forward all the way up to the front seat. It has a sliding seat track.
First, lift the T handle under the seat cushion on the left front side of the seat. This will allow you to lift the seat bottom up all the way to lcok in the full up position.
Then, lift the lever on the same side of the seat and slide the seat forward. It will stop in 4 places.
Rear -Rear
6 inches forward of that.
another two ft to the second row seating position
full frward against the front seats.

Pleae rate as fixya if this helps.

c4253aa.gif Seat —Third Row Bench Removal
sxv~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Removal of the third row bench seat requires more than one technician.
  1. Remove the second row seats. For additional information, refer to Seat—Second Row .
  1. Remove the floor mats.
  1. Lock the seat cushion in the upright position.
    1. Lift the handle to release the cushion.
    1. Lock the seat cushion in the upright position.
0235766.gif
  1. Move the third row bench seat to the second row position.
    • Lift the seat track release handle.
  1. Remove the two bolt covers.
  1. Remove the two seat track front bolts.
  1. Remove the four seat track rear bolts.
    1. Position the rear seat cushion floor cover aside.
    1. Remove the four seat track rear bolts.
  1. Remove the third row bench seat.

Mar 02, 2009 | 1997 Mercury Villager

3 Answers

2005 Dodge Durango


I have an 06 - I pull up on the bottom front of the seat cushion only and pull forward then the back of the seat drops down.

Aug 03, 2008 | 2005 Dodge Durango

1 Answer

2004 toyota highlander -


Most dealers will not perform this service, as they become the "final stage manufacturer", and what that means is THEY would be responsible for any claims (liability) that may arise from an accident. Toyota does NOT recommend adding seats, nor do they recommend changing seat types (buckets vs bench). Note that the vehicle is designed with the specific seating positions in mind. To add a 3rd row seat, you would also have to install the proper seatbelts, and secure the 3rd row seats in a fashion that meets NHTSA specifications.
In short, and I apologize for this, please refrain from doing it.

Jul 13, 2008 | 2004 Toyota Highlander

Not finding what you are looking for?
2001 Oldsmobile Silhouette Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...