SOURCE: vw golf 2.0 gti, overheating,
Sounds like you may need a new Thermostat.
Get a Haynes or Chilterns manual and a new Thermostat for the carfrom a car parts place like Autozone. Its normally a simple opperation to change it.
SOURCE: clutch adjustment
I do not think that I will use your service in future.
I had a straight query that required a one line answer.
So all you are pushing is your premium service.
Nice try.
SOURCE: how do i reset the engine warning light
Drive 50miles and it should automatically go off, however if the light reappears then take the car to the dealers where they will diagnos the engine. In addition you may take out the battery and leave it for 5mins as this resets the ECU, but this is a hassle as the alarm can malfunction and the cd codes/ cassete player codes would be needed.
SOURCE: VW Golf Starting Problems
I HAVE THE EXACT PROBLEM!!! OK.. SO FINALLY AFTER A MONTH OF TRIAL AN ERROR.. I REPLACED THE COOLANT TEMP. SENSOR AND SERIOUSLY.. ALLLLL THE PROBLEMS WENT AWAY AND MY SYMPTOMS WERE IDENTICAL TO ALL 3 OF THE PEOPLE REPORTING THIS SAME PROB. ITS A $7.00 PART SO GRAB IT AND CHANGE IT.. IT IS VERY EASY TO SWITCH OUT AND I BET YOUR CAR RUNS AWESOME AGAIN :) GOODLUCK!! -MANDEY
SOURCE: Need help fitting a clutch on a VW GTI Golf
undo centre wheel hub nut 30mm/32mm, socket. undo lower wish-bone outer bolts, disconect battery,/remove starter motor,/remove transmission mounting bolts to body frame ,/ remove all surrounding bolts around bell housing transmission,/ remove clutch cable from transmission,/ remove drive shafts from centre hub and transmission,/ make sure car is standing on axle stands at front of jacking points,/use a trolley jack to suport engine sump with a piece of wood,/ slide transmission away from flywheel,/lower transmision on floor,/undo all clutch plate preasure bolts 10mm,/remove thrust bearing located on centre transmision shaft ,.also make sure if fitted speedo cable needs to be removed.new clutch plate should indicate flywheel ,without fitting clutch plate wrong way round/otherwise transmision will not bolt to engine block.,
157 views
Usually answered in minutes!
×