Question about Land Rover Range Rover

1 Answer

I have a 1996 rangerover 4.6 hse v8 engine. How do you change the radiator?

Posted by wickida on

Ad

1 Answer

gypsydamifin

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

When you open the hood if you look striaght down there is a panel with 3 bolts it is the radiator header panel undo those 3 bolt ..remove the upper hose clamp and the lower hose clamp the water and antifreeze will run out remove these hoses from the radiator lift it straight up and otu ..

Posted on Feb 10, 2011

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Coolaant for a 1998 frod f150 xlt triton v8 4.6 how much


I found this BUT it sure reads like a LOT!

Coolant capacity Ford F150 Forum Community of Ford Truck Fans

4.2L V6 engine with 1 row radiator 19.0L (20.1 quarts)

4.2L V6 engine with 2 row radiator 20.4L (21.6 quarts)

4.6L V8 engine with 1 row radiator 19.5L (20.6 quarts)

4.6L V8 engine with 2 row radiator 21.9L (23.1 quarts)

5.4L V8 engine with 1 row radiator 22.6L (23.9 quarts)

5.4L V8 engine with 2 row radiator 24.1L (25.5 quarts)

They also recommend this Link:
https://www.fleet.ford.com/partsandservice/owner-manuals

Anthony

Apr 17, 2018 | Cars & Trucks

1 Answer

How do I change the radiator on a 96 lincoln contiental 32v intech V8 ?


RADIATOR
Removal
1. Disconnect battery ground cable.
2. Drain engine cooling system as described.
3. Remove engine air cleaner.
4. Remove upper radiator hose from water bypass tube.
5. Remove radiator overflow hose from radiator and fan shroud.
6. Remove transmission oil cooler line from oil cooler inlet fitting.
7. Remove nuts retaining A/C condenser core to the radiator.
8. Disconnect engine control sensor wiring from the auxiliary electric cooling fan motors and the CCRM.
9. Raise vehicle on hoist.
10. Remove splash shield from lower radiator support and front sub-frame.
11. Remove lower radiator hose from radiator.
12. Remove oil transmission cooler line from oil cooler outlet fitting on radiator.
13. Remove retaining screws for power steering/transaxle oil cooler and position cooler aside.
14. Support fan shroud, radiator and A/C condenser core with a suitable jackstand. Remove lower radiator
support.
15. Position jackstand aside and carefully remove radiator and fan shroud.
16. Remove two retaining bolts for fan shroud at top of radiator and remove fan shroud from radiator.
17. Remove upper radiator hose from radiator.
NOTE: Loosen transmission oil cooler lines while securely holding radiator
connector with a back-up wrench.
NOTE: Loosen transmission oil cooler lines while securely holding radiator
connector with a back-up wrench.
18. Remove Radiator

Apr 19, 2015 | 1996 Lincoln Continental

1 Answer

Would my computer box for my 1999, Land Rover-Rangerover 4.6 L HSE burn if a couple chafed live-wires under the fuse box in the engine compartment grounds out on the body?


there should be a fuse for the power supply for the ECM. However if you know of the chaffed wires then it is best that you do something about it . If the power wires are before the fuses then there could be an electrical fire and after the fuse then you will keep blowing fuses and stop what ever those wires support.

Nov 23, 2014 | 1999 Land Rover Range Rover

1 Answer

How do i engage into 4 Wheel Drive Mode on my V8 4.6 HSE


a 1999 landrover Range Rover is in constant 4 wheel drive. the only change you can make is high or low range and this is handled through the gear shift selection.

Feb 13, 2014 | 1999 Land Rover Range Rover

1 Answer

How do i change a water pump on 1996 grand cherokee limited V8


I'll assume you have a 4.0l

The 4.0L engine is equipped with a reverse rotation (counterclockwise) water pump. The word REVERSE is stamped or imprinted on the cover of the viscous fan drive and on the inner side of t he fan. The letter R is stamped onto the water pump impeller. When replacing water pump, ensure proper pump is installed. Installation of the wrong water pump will cause engine overheating.

NOTE:On models with 4.0 L engine, front grill must be removed to access radiator draincock. Draining cooling system can be accomplished by removing drain plug from side of block as well as by loosening radiator draincock. Drain plug is located on lower left side of engine block.

Disconnect negative battery cable. Drain cooling system. Disconnect electric cooling fan connector. Remove electric cooling fan and electric fan shroud assembly (if equipped).
Loosen, but do not remove, 4 water pump pulley-to-water pump hub bolts and 4 viscous fan-to-idler pulley nuts. Remove accessory drive belt. Remove 4 viscous fan to idler pulley nuts, and remove fan and shroud together.
Remove 4 water pump pulley bolts and remove pulley. Remove power steering pump and bracket. Disconnect heater hoses and lower radiator hose at water pump. Remove 4 water pump retaining bolts. Remove water pump.

to install just reverse procedures

Apr 05, 2010 | 1996 Jeep Grand Cherokee

5 Answers

Range Rover 4.6 HSE. 97' 1. What does HSE


The HSE designation refers to a Sport Edition 'Rover, not a higher-priced premium edition.
Changing fuel grades can harm an engine that doesn't have computer controlled valve timing.
Symptoms include a pronounced, fast "knock" (usually when you go from 93 to 87 octane) and using a fuel with a higher octane rating than the vehicle requires (example: 93 versus 87) sends unburned fuel into the emissions system and catalytic converter. This puts stress on the emissions system. For some vehicles, a rotten egg smell or a pop when the fuel burns off in the catalytic converter coming from the tailpipe signals use of higher than needed octane gas.
More info on your problems here, as well as useful links:

http://www.rangerovers.net/newrremedies.htm

HOPE THIS HELPS! Don't forget to rate!

Jan 09, 2010 | 1998 Land Rover Range Rover

1 Answer

I need to know the location of the Thermostat on my 1996 Jeep Grand Cherokee,


If you have a V8 the thermostat is located under the coolant inlet tube. The tube is located on top of the engine, in the front about center. The thermostat is hard to change. Locate the upper radiator hose on your radiator and follow it to the engine block it is located on the top front part of your engine and you must lean over the front and look down onto the block to see the thermostat housing.

Oct 29, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...