Check and clean the terminals then boost the car to start it after it starts. Well it's running take off the positive terminal if the car stops running the alternator is no good and you have to replace it.
SOURCE: The last couple of days
First think is to check the fuses. Next check that the main relay is supplying voltage on the output pin. If there is no voltage output then it could be a dry solder joint on the main relay. Unplug it and remove its cover lid carefully. Visually check the circuit board and look for a hairline annular crack around a dry looking soldered pin. Use some flux cored solder and a soldering iron to resolder this joint. Replace the relay lid and plug it back in and it should be OK.
SOURCE: factory alarm started acting up a few days ago,
Could be the battery is dead or dieing. When batteries start to go they will cause the security to act up. Plus other things
SOURCE: factory alarm started acting up
The first thing i would do is to have the battery tested, most problems occur due to a weak battery so i would start by having the battery tested first you may have a low weak battery thats why you were able to jump start it . good day.
SOURCE: I have a 2006 Pontiac
sounds like a problem with the ignition barrel.the wiring is loose or the connectors are loose or the barrel is faulty,unless thse are all run from the onboard computer.
339 views
Usually answered in minutes!
×