How do you program a new cut key for a 2007 Jeep Compass?

here are some youtubes on how to do this pick one that looks like you can follow and see if it works out for you. it sure looks like it will be a job. good luck on this job.

https://www.youtube.com/watch?v=y_Lgi7xjFIs https://www.youtube.com/watch?v=Z4vTZgh48AU

I would expect will need to have the OBD read and reset from there

Hey Mary Jo,
Seems like this is a common problem, here are a couple sites that might help:
2007 Jeep Compass Rusted Out Subframe And Spring
2007 Jeep Compass Suspension Cross Member Subframe OEM Suspension Cross...

just the beep, all other 1000 things on car work?
yes, id buy a new jeep. (like the joke with ash tray full... LOL)
or replace the beeper $$$$$

IMMO cuts fuel. that is its job, fix that secuity system.
the FSM covers this.
if you tried both the key fobs , that came with car?
do so... now....!

if not why not?
are you using only a single key , to test this? do so.
no other keys near ignition switch.
do have this, the oper guide?
page 14?

http://justgivemethedamnmanual.com/jeep/jeep-compass-owners-manuals/

next is to read the IMMO sections (immoblizer) in FSM
or alldata.com to find true cause of IMMO tripped.

quote page 14, (it's clear , no?)
SENTRY KEY
The Sentry Key Immobilizer System prevents unauthorized
operation of the vehicle by disabling the engine.
The system will shut the engine off after 2 seconds of
running if an invalid key is used to start the vehicle. This
system utilizes ignition keys which have an electronic
chip (transponder) embedded into them. Only keys that
have been programmed to the vehicle can be used to start
and operate the vehicle.
The Sentry Key Immobilizer System does not need to be
armed or activated. Operation of the system is automatic
regardless of whether or not the vehicle is locked or
unlocked. During normal operation, the Theft Alarm/
Immobilizer Light will come on for three (3) seconds
immediately after the ignition switch is turned on for a
bulb check. Afterwards, if the bulb remains on, this
indicates a problem with the electronics.
If the bulb begins to flash after the bulb check, this
indicates that an invalid key has been used to start the
vehicle. Both of these conditions will result in the engine
being shut off after two (2) seconds of running.
Keep in mind that a key which has not been programmed
is also considered an invalid key even if it is cut to fit the
ignition lock cylinder for that vehicle.
If the Theft Alarm/Immobilizer Light comes on during
normal vehicle operation (vehicle has been running for
longer than 10 seconds), a fault has been detected in the
electronics and the vehicle should be serviced as soon as
possible.
14 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
end qoute:

Check the fuse for that side yes you have a fuse for each high and low beams for each side

Almost all new vehicles have what is known as speed limiter. Once a vehicle reaches a certain "max speed" as deemed by the manufacturor.. it will cut the power to your vehicle.
This is very common in new cars.

Using your VIN your Jeep dealer should be able to make you a new key. Make sure you take your ID with you.

reboot the computer by disconnecting the battery and reconnecting

Gap is the same as original ones...should be on an under-hood sticker...Likely 35.