Blower Motor
REMOVAL & INSTALLATION
Front
Fig. 1: Front heater blower motor assembly
Remove the glove box to access the front blower motor, which is on the firewall
The blower motor is retained by four bolts (arrows)
The blower motor vent tube helps to cool the blower motor for efficient operation
Push up on the clip to remove the blower motor connector
A ratchet with extensions makes removal of the retaining screws easier
Lift the blower motor over the control cable . . .
. . . and remove it from the vehicle
- Disconnect the negative battery cable.
- Open the glove box door. Gently squeeze the retainers at the rear of the box inward and allow the box to swing downward.
NOTE: If additional access is required, unfasten the glove box hinge retainers and remove the assembly.
- Label and disconnect the electrical harness from the blower motor.
- Remove the blower motor housing tube and/or blower motor cover.
- Remove the blower motor retaining screws.
- Remove the blower motor from the A/C evaporator.
To install:
- Install the blower motor in the A/C evaporator and tighten the retaining screws securely.
- Install the blower motor housing tube and/or blower motor cover.
- Connect the electrical harness to the blower motor.
- Reinstall the glove box and close its door.
- Connect the negative battery cable.
Rear
Fig. 2: Service cover push pin locations
- Disconnect the negative battery cable.
- Remove both rear passenger seats.
- Remove the three push pin retainers from the lower edge of the auxiliary heater and air conditioning service cover.
- Lift the service cover outward and upward to remove.
- Label and disconnect the electrical harness.
- Remove the blower motor housing tube.
- Loosen the three retaining screws and remove the blower motor.
To install:
- Install the blower motor and tighten retaining screws securely.
- Install the blower motor housing tube.
- Connect the electrical harness.
- Position the service cover and install the three push pin retainers from the lower edge of the cover.
- Install both rear passenger seats.
- Connect the negative battery cable.
×