Question about 2004 Chevrolet Aveo
No point wondering - only examining the door internals will reveal why the latch doesn't work. Mostly it is the result of poor maintenance, the result of a maladjusted striker/hinges or a very dusty environment, though sometimes a spring will break...
Posted on Sep 14, 2017
you have to pm me if it was me you where trying to get otherwise they just go back on the message board and there is hundreds and hundreds on there. if you can get the front grill off you can access the latch from there and a bit of fiddling with a screwdriver will help. if this helps please rate me joe
Posted on Nov 21, 2008
SOURCE: Stuck door latch 98 K1500
never shut the door to test and always remove ign key as sometimes door lock automaticly,as to why doors will not open did you refit the connection from handle to the lock little metal rod with a plastic clip to hold it on ??assuming it has one as i have never seen a chevrolet only an astro van here in spain .to test without shutting door use a screwdriver to close the mechanism .sorry i couldnt be more helpful
Posted on Dec 16, 2008
carefully use a screwdriver or chisel to pry the interior panel off of the door...it's thin, like an upholstered piece of hard board, held on by plastic ribbed push-studs, every so often. Those studs can be pryed out and pushed in to reinstall many times if you're careful but I did manage to break one on my truck. Of course there is also a couple of screws near the door handle as I recall but they are visible. A small piece of triangular shaped plastic must also be popped / pryed off of the forward window area. I'm drinking right now, but I think you may have to drill out a rivet to remove the old handle assembly but it is really easy, just pick a drill bit about the same diameter as the rivet and drill it till it falls apart. Install the new assembly with a pop rivet of your own. good luck
Posted on Feb 09, 2009
Make sure it is not binding/sticking where you pull the release cable.
Drench the entire works in WD-40. Push it back and forth until it moves with no resistance.
Make sure the part that hooks onto the latch hasn't come loose enough to not slide over when it makes contact.
If that doesn't work, take the whole thing off. You'll have to anyway to replace it. Chances are with it disassembled you'll see what's wrong.
Posted on May 24, 2009
The only suggestion that I can think of is to have someone push up and down on the hood while you pull the cable. This might lower the tension on whatever is binding. If there is a way to spray some lubricant with a plastic tube into the latch area, I would give it a try. Sorry this isn't more helpful. Just be glad it's not a Jag. Takes 5 hours of labor to open the hood on some models after the hood release handle breaks. Good luck!
Posted on Mar 10, 2010
Tips for a great answer:
Mar 10, 2016 | 1999 Cadillac Eldorado
Apr 19, 2013 | 2001 Chrysler Town & Country
Apr 02, 2013 | 2002 Ford Taurus
Nov 08, 2010 | 2000 Volkswagen Cabrio
Jul 16, 2010 | 1999 Dodge Intrepid
Jan 28, 2010 | 1999 Jeep Grand Cherokee
Dec 26, 2009 | 2000 Jaguar S-Type
Nov 26, 2017 | 2001 Volkswagen Cabrio
70 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: