Question about 2006 Jaguar XJ8

1 Answer

My jaguarxj8 will crank over but will not fire.i am told there is a reset button,can you tell me where it is .thanks

Posted by cristom on


1 Answer

Dave Quincey

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 57 Answers

Pull the carpet back in the right hand foot well, reach behind the foot well side plate on the right and you will find a black, cylindrical device with a rubber top. Press down on the rubber top with your finger and the device is then reset

Posted on Dec 27, 2010


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

EF ford on gas cranks but will not fire have changed coil pack and have power to the main loom (plug) to coil pack

Check crank position sensor or cam position sensor if applicable. Is it actually sparking? If so either its not being told when to fire or there is something else telling it there's no fuel etc. Check the relay box for fuel relay etc.

Mar 30, 2015 | Ford Cars & Trucks

1 Answer

Does a 1987 Ford, 302 have a crank sensor?

Hi Brad,
That unit does not have a crank sensor per say the PCM is told where #1 cylinder is by a short air gap in the Distributor that goes by the Stator and that tell the ignition when to fire. I hope this helps you Brad!!!!!

Sep 25, 2013 | 1987 Ford F 150

1 Answer

My 1996 jeep grand cherokee will not start i broke down on the road and had it towed away, they called me and told me it was the idle that got reset, so i went and picked it up it ran for a day then it...

Can't tell you what it is without testing, but you need to check the crank position sensor and fuel pump. Both will cause it to stall and, when they cool down, it will re-start.
Easiest way to check pump is to turn the key on and listen at the tank. If you can't hear it running, it's not.

Feb 06, 2011 | 1996 Jeep Grand Cherokee

2 Answers

97 seabring put new water pump on thought i set it back in time all marks line up but no fire rotor button faces number 6 plug not 1

the crank shaft mark is 180 degrees of. It has to be set on the compression stoke. You set yours on the exhaust stroke. Sorry

Feb 04, 2011 | Chrysler Sebring Cars & Trucks

1 Answer

Was told cam postion sencor might be bad? Replace not it! now was told my autozone guy might be crank sencor? But need a pix or something i can't find it? your help is needed! Thank you Darren

well i dont know what year is but the crank position sensor is locate it behind crank pulley in order to have acces to the sensor you ne to remove the pulley first. Note when the crank sensor is bad there should be no fire at your sparks. before keep spending more money dont know if you checked for gas coming to the engine.

Sep 18, 2010 | Ford Escort Cars & Trucks

1 Answer

My car wouldnt start one day out of the blue. i was told to spray starter fluid on it and it stated but it jerks when i drive it. whats wrong?

Crank or cam shaft sensor fuel pump,its relay or circuit.
Cam/ Crank sensor tell ECU which injector to fire.

Apr 08, 2010 | 2002 Chrysler Sebring

1 Answer

Car won't start? 1992 Buick LaSabre

three core plug hahahah it has 3 coils crank sensor is located at the crank pulley it sits inside and creates a magnetic field and produces a low ac voltage 5 ac volts or less module then converts it to a squar wave to fire injectors and coils

Apr 24, 2009 | Buick LeSabre Cars & Trucks

1 Answer

Car won't start, 2000 prsche carrera 911

Start by squirting a little fuel into the throttle body and then crank it and see if it fires up .. if so its a fuel problem if not its going to be something in the electrical. holler if you need more thanks Jerry

Jan 30, 2009 | 1998 Porsche 911 Carrera

1 Answer

Fuel filter reset button

there is no such thing as a filter reset button. you statedc that it won't turn over do you mean that if you turn the key they engine don't crank? or it cranks but don't start? please post back

Jul 18, 2008 | 2000 Chevrolet Silverado 1500

1 Answer

2000 gmc savana

please let me know what i told you to do and what's the original problem? crank won't start? or no crank no start? and please tell me what i told you to do and engine size thanhk you

Jun 06, 2008 | 2000 GMC Savana

Not finding what you are looking for?
2006 Jaguar XJ8 Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers


Level 3 Expert

85239 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides