Question about 1997 Oldsmobile Regency

1 Answer

Heat turns on - blower motor not working. 1997 olds regency

Posted by telstar56 on

Ad

1 Answer

Robbie Pena

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 375 Answers

Check fuses if they are still good change the blower motor instructions below not hard to do!

  • Disconnect the negative battery cable.
  • Disconnect the blower motor lead connector from the wiring harness connector.
  • Remove the blower motor cooling tube from the blower motor.
  • Remove the four retaining screws.
  • Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
  • Lift up on the blower and remove it from the blower housing.
  • Installation the new blower motor by reversing the removal steps.
  • Connect the negative battery cable.
  • Posted on Jan 11, 2011

    Ad

    Add Your Answer

    ×

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    Wheres the blower motor relay located on a 1998 olds regency


    the blower motor relay(resistor block) is under the hood on the passenger side on the firewall. but this is not your problem with these symptoms, you need to take the car to a garage and have it checked out and repaired.

    May 05, 2014 | 1994 Toyota Previa

    1 Answer

    Blower motor stops working randomly


    May be a worn out blower motor or burnt wire on resistor for blower motor

    Nov 15, 2012 | Cars & Trucks

    1 Answer

    WHERE IS BLOWER MOTOR RESISTOR ON OLDS NINETY EIGHT


    Its on the passenger side of the heat duct mounted with 2 screws

    Jan 26, 2012 | 1996 Oldsmobile Ninety Eight Regency

    1 Answer

    Fuse blows when you push the button in for heat or air\r\n1986 olds 98.where is the relyay that control the heater,blower motor


    It should be under the hood in a fuse box & look on the underside of the top of the fuse box cap.

    Apr 20, 2011 | 1986 Oldsmobile Regency

    1 Answer

    Having problems with turn signals as well as hazard light not working properly ,we change turn signal switch as well as fuses. THIS IS 1997 OLDS REGENCY 3.8


    there are two different flashers for this they may both be bad turn on flash and listen for the clicking noise if it doesnt and just the light comes on replace also check to make sure all your bulbs are good this can also cause this

    Feb 14, 2011 | 1997 Oldsmobile Regency

    1 Answer

    No heat or air blowing out my blower have already changed the blower motor still nothing


    I would check the fuses to be sure no issue there, then... I would check the blower resistors next. This should be a module very near or mounted to the blower motor.

    Nov 15, 2009 | 1995 Oldsmobile Ninety Eight Regency

    1 Answer

    1991 olds 98 regncy elite blower motor not working


    There is a fusible link for the blower motor. Check that. Don't know where it is. Look up the wiring diagram at autozone.com. Also check the fuse in the fuse box. Could just be that.

    Feb 24, 2009 | 1991 Oldsmobile Ninety Eight Regency

    Not finding what you are looking for?
    1997 Oldsmobile Regency Logo

    308 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Oldsmobile Experts

    Marvin
    Marvin

    Level 3 Expert

    85239 Answers

    Joe Taylor
    Joe Taylor

    Level 3 Expert

    2228 Answers

    Thomas Perkins
    Thomas Perkins

    Level 3 Expert

    14850 Answers

    Are you an Oldsmobile Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...