I am getting a code of p0506 from autozone. How can this be fixed?

P0306 is a misfire on cylinder #6 P0174 is a lean code for bank 2 ,P0506
https://www.obd-codes.com/p0506

Check Engine light Code P0506 Throttle Body Idle Air Control (IAC) System RPM Lower Than Expected, Do not waste your money Solve the problem of code Throtte Body P0506 with three dollars video Part #1 Remove Throttle Body

http://www.autozone.com/autozone/parts/Duralast-Idle-Air-Control-Valve/1999-Buick-Lesabre/_/N-jd47xZ9gsof?itemIdentifier=91113_0_0_Idle control system high(rpm).This is what it states for code P0507.Code P0506 is for low(rpm).Buicks have a history for sensors that go bad and hard to find which one without replacing some that are good.Here is a part to check out,Click on link to view.

A P0506 DTC trouble code may be caused by a

Damaged/failed/dirty throttle body. clean throttle body, especially around the throttle plate where carbon gets on it. erase the code and see if it stays out. if not call the ford garage, there may be a TSB for this code. good-day!

did you try disconnecting the battery and then reconnect battery, it works a lot like a hard boot on a PC in fact that is what your doing to your cars computer

Change the fuel filter and drive it about 30 miles. it should reset the codes to normal.

P0506 - Idle Air Control (IAC) System RPM Lower Than Expected

This P0506 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0506 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is lower than the desired (pre-programmed) RPM.

Potential Symptoms: Most likely the only thing you'll notice is the idle speed is lower than normal so it will likely be rougher. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.

Causes: A P0506 DTC trouble code may be caused by one or more of the following:
* A vacuum leak
* An air restriction in the intake air path or exhuast
* A faulty positive crankcase ventilation (PCV) valve
* Damaged/failed/dirty throttle body
* Internal engine problem
* Failed PCM

Possible Solutions: This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect for vacuum leaks, restrictions, and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.

Hope helps.

Hi, the P0141 is the O2 sensor, more info @ http://www.obd-codes.com/p0141 . Also P0506 code is Idle Air Controller problem - http://www.obd-codes.com/p0506

click on the below links for code details.
P0106

P0121

P0171

P0174

P0335

P0340

P0385

P0442

P0506

P0507

P0601.

all of the above codes seem to have a common cause, they all list a bad ecm (computer) as being a cause, and the last code P0601 points specifically to a bad computer. sorry for the bad news, hope this helps.

This P0506 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0506 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is lower than the desired (pre-programmed) RPM.
Causes:
A P0506 DTC trouble code may be caused by one or more of the following:
· A vacuum leak
· An air restriction in the intake
·
· air path or exhaust
· A faulty positive crankcase ventilation (PCV) valve
· Damaged/failed/dirty throttle body
· Internal engine problem
· Failed PCM

This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect for vacuum leaks, restrictions, and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns