SOURCE: power steering belt on a 94 camry v6
only 2 bolts. They are hard to get to at the back of the engine but one is the mounting one and the other is the locking one for the adjuster once you get them lose you can undo the adjuster bolt and take tension off of belt then pull it off and replace it.
SOURCE: 2003 Camry won't stay idling after I changed battery
This is extremely common :)
With time your throttle body gets gummed up with oily residue from the PCV system. As this happens, the computer adapts to the restriction it causes in the throttle body.
When you unhook the battery, these learned values are lost and the default settings for idle control are used. Unfortunately the default settings are no longer sufficient to keep the idle correct with it all gummed up.
Take your intake hoses off the throttle bodies and clean the insides (open the throttle plates for better access) with a rag and some brake parts cleaner or throttle plate cleaner, available from your local parts store.
Reassemble and start the car, your idle problems should be gone immediately.
I
SOURCE: I have a 94 Camry V6. Brake light went on about a
Hi:
All modern cars have a dual brake system, this way if you would happen to spring a leak in your rear brakes, your front brakes still work. When one system fails, you get a brake light. In your case, the first place to start your troubleshooting is to check the fluid level in the brake reservoir. If either the front or back of the reservoir is empty, you have a leak. If both are still full, the most likely problem is your master cylinder failing. If you think you have a leak, look at the inside edges of all 4 wheels, and look for signs of brake fluid .
SOURCE: 1998 Toyota Camry tail lights and backup lights won't work
Hello.
I have a solution for you, as I see your same issue in my shop quite a bit...There are two possibilities:
You may have a broken wire. This is a very common issue.
Open up the trunk lid, and look at the hinge on the driver side. You will see a wiring harness, in a plastic tube, attached to the arm that holds th trunk lid to the car.... Remove the tubing, and follow the wires towards the back seat area. You are probably going to find a wire that has been broken, from the many actions of opening and closing the trunklid. Splice and resolder the wire, and you should be fine.
The other issue is the tallamp failure sensor may have burned out. This too is rather common. Open the trunk lid, and pull back the inner carpeting on the driver side of the trunk. Locate a small box (it will be white or blue), on a brace. The box is closer to the quater panel sheetmetal. Remove the box, and take it apart. If it looks or smells burnt, you need a new sensor.
SOURCE: will a 94 toyota camry engine fit in a 92 toyota
provided the body styles are the same it should
118 views
Usually answered in minutes!
do u here it crank tell me what about the main fuse are you sure u checked them
×