Inline fuse Where is the inline fuse located for a 93 toyota paseo aternator?

If I remember right there is a fuse or fusible link near the pump itself. Please have a mechanic check for the fuse or fuse link

Vehicle Won't Crank Due To Starter : Toyota Paseo ...

repairpal.com > Problems > Toyota > Paseo

Engine Won't Crank Due To Starter on Toyota Paseo ... My car is turning over, getting gas and all my spark plugs have fire, but it will not start. Wh... 1993 Toyota Paseo ...car won't start, problem isn't starter but i think it's in the wiring. i can start ...

Paseo Fuel Filter Help - Toyota Nation Forum : Toyota Car and ...

www.toyotanation.com > ... > Tercel, Paseo, Starlet, and Sera Forum

Mar 11, 2009 - 7 posts - ‎3 authors
Does anyone have suggestions on how to replace the fuel filter on a 1993 Paseo? ... I started trying to get at the filter which is located against the firewall ... as I need to unplug some electrical connection, which isn't budging, ... 1993 Camry LE 2.2L Won't Start - Help!
15 posts
Feb 6, 2012
Please Help! Gas Gauge Stopped Working
13 posts
Nov 29, 2010
93 corolla 1.8 automatic won't start help!
15 posts
Jul 26, 2009
Fuel pump not getting power (1989)
3 posts
Sep 11, 2007
More results from www.toyotanation.com

it is located under the hood in a Black Box look ther for it or under the dash for another box to see were it is Use A Light too see it

the clutch switch my be going bad is the the one behind the slutch peddal that you have to press i n order to start the car but if the car does actualy turn but it doesent turn on you might want to change spark plugs or chec cables

Your gas relay is located in the fuse box under the hood you will see 2 silver relays it is the one that is up and to the left. Hope that helps

PENDING ON THE TIRE MAKE AND MODEL THE TIRE PRESSURE IS ON THE SIDE OF EVERY TIRE IN KILAGRAMS AND PSI MAX PRESSURE KEEP ABOUT 5 POUNDS UNDER MAX PRESSURE

There is fuse called the max fuse. It is located real close to the battery inline with the possitive cable. Replace fuse and should be fine.

Hi,

You could see the loation of the starter on the bell housing of your transmission.
Just follow the big diameter positive(+) cable, going down into the transmission, at the end of that cable is the starter assembly. Easily reconize with a rounded tube on top with wire connected on it.

Hope that helps you out!

Thanks for using Fixya!

The starter won't get hot while the car is running. The starter only works while you are cranking it over. After running a while and the car is hot, feel if your battery is not over heating. If the vaultage regulator in the alternator is bad the battery may be overcharging causing it to over heat and not want to work when boiling. After it cools down it may work again.
I this will help.
Sam

you may have missed a fuse or fusible link , there is a 100amp alternator fuse and a 50 amp fuse on that circuit , location of those 2 fuses are (left side of engine compartment) also there is a fusible link in that circuit right off the positive side of the battery , those big fuses don't look anything like a normal if that helps , cheers'