My Suzuki jimny will not go into four wheel drive, the four wheel drive light is on on the dash,it is a 2004 thanks.

Start by looking at the fuse box... check all the fuses. Next possibility is a relay.

The Suzuki Jimny Transmission Control Module (TCM) is an electronic circuit component that controls gear shift, TCC lock-up and idle-up according to the signal from each sensor. It is a microcomputer consisting of an IC, transistor, diode, etc. It is installed behind glove box.

1. Ignition switch
2. Transmission range sensor
3. Input shaft speed sensor
4. Output shaft speed sensor (A/T VSS)
5. Shield wire
6. Vehicle speed sensor (VSS)
7. Transmission fluid temperature sensor
8. Shift solenoid-A (Shift solenoid No.1)
9. Shift solenoid-B (Shift solenoid No.2)
10. Shift solenoid-C (Shift solenoid No.3)
11. Shift solenoid-D (Shift solenoid No.4) 12. TCC solenoid (Lock-up solenoid)
13. "O/D" cut switch
14. "O/D OFF" lamp
15. Monitor connector No.2
16. DLC
17. To ECM
18. To A/C
19. To brake lamp switch
20. To main relay
21. Terminal arrangement of TCM coupler

4w wait detect switch not working or the actuator

bulb gone?

Did you reverse more than 10 metres? Sounds like the hubs are locked into 4wd.this will work if you have auto hubs.but sometimes you have to turn the hub manually if they don't disengage.if you have gone some time or distance in 4wd

Elizabeth: It could be the power train module. This is a computer that tells the drive train everything (like what gear to be in and how much gas to add). Part of the power train module goes to your dash lights. It is usually located underneath the center console, or under the driver's seat or sometimes under another seat. You can go to the wrecking yard, get one that is for your trailblazer and try that.

After searching on the net we saw a blog that said in rrsponse to having the rattle to ring the suzuki customer service hot line so we did. Found out that our jimny had a VIN number that was part of a recall that is still current. We booked in to get the rattle fixed at no cost they said for 12 Jan 2015. However today as we were driving along the steering column broke completely. We got the jimny towed to the same suzuki dealer and will be fixed free of cost next week. Moral of the story is ring Suzuki customer care and don't put it off!

sounds like an electrical issue possibly caused by loose terminals or a loose ground check your connectors might be a cluster issue

For 4 Wheel drive related problem,click the link below and go through the troubleshooting procedure:---

Car will not go into 4WD high or 4WD low?

http://schematicsdiagram.blogspot.com/2011/12/car-will-not-go-into-4wd-high-or-4wd.html

-------------

4X4 Truck makes roaring noise in the front end?

http://schematicsdiagram.blogspot.com/2012/01/4x4-truck-makes-roaring-noise-in-front.html

-----------

No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html
----------4 wheel drive system will not disengage?

http://technoanswers.blogspot.com/2012/01/4-wheel-drive-system-will-not-disengage.html
------4WD light is flashing and beeping? NO 4WD high?
http://schematicsdiagram.blogspot.in/2012/02/4wd-light-is-flashing-and-beeping-no.html
--------This details will help.Thanks.

wore eletrishifter tranfer case need repair

If you need further help, reach me via phone at https://www.6ya.com/expert/scott_541ceb86d69e7743

Either a short in wiring; a fuse is needing replacing or the engine is not running properly, which will cause the light to come on.