Actually the 2006 does not have a lever. Instead it has a small 5mm size hex screw head that you must turn to release the entire mechanism. Once you release the hex 5mm bolt then you can see a metal lever that you must depress to release it completely.
Open the hood / bonnet, look behind the headlamp and you will see a Black lever, pull down (very stiff) and the whole lamp will release
SOURCE: how to replace left headlight bulb
all you need is the bulb part of it,it just turns out from the back of it,and put the new one in it,be care full and don't touch the actual bulb part of it,your not supposed to touch them with your fingers hold it with a cloth rag or something but the old one just pulls out and the new on goes right in,and that's all there is to it,,good luck,i hope this help
SOURCE: Replacing 2006 VW Beetle headlight How do you do
This is based on my 2001 Beetle, so hopefully they didn't make it any more complicated by the 2006 model year.
Open the hood and look at the inside of the headlight housing. Going from the back of the housing toward the front, there's a metal clip, then a plastic lever, then a little rectangular button with dots on it. These are all right next to each other. Pop off the metal clip, press down on the little rectangular button, then pull up on the plastic lever. It's kind of like a childproof pill bottle cap, I guess. Once you've done all those maneuvers, the headlight housing should slide out the front. Then you can unplug the wires and replace the whole unit, or open up the unit and replace just the bulb.
Since you're working on the driver's side, you'll also have the added joy of trying to work around the battery compartment. You may have to take the battery cover off to get enough room.
SOURCE: How do I unlatch the headline of a 2006 VW Beetle,
There is a release lever on the side of the headlight assembly under the hood.Its a black lever, Just pull upward until it slides up and headlight will slide out of the vehicle.just simply reverse the procedure for installation.
SOURCE: I need to know the step on how to replace
There are two spring clips located under the hood around each headlamp housing. Open both clips and extract the headlamp housing from the front of the car by pulling the plastic assembly by grabing the edges by the black rubber seal. The entire headlamp housing will pull out from the front bumper enough to allow you to change the bulbs. Repeat procedure and clip the spring clamps back in place.
176 views
Usually answered in minutes!
×