Reinstalled front sway bar with new OEM end links and new rubber bushings both sides . it now clunks ... knocks r and r 3 more times and can't get it right

It's usually a sway bar link and/or sway bar bushing.
Disconnect it and try that for less noise before buying parts.

They are really bad for the lower control arm bushings causing a clunk noise. You can't see movement by checking on a hoist, but lubing them will help only temporarily. I did a lot of them under warranty, but being 2005 I'm sure yours has expired. I' would highly recommend changing them to eliminate the clunk noise.

the sway bar is a bar that runs acrossed the front of the van from strut to strut. It is bolted to the cradel and then has links that run from the bar to the strut to increase stability. The sway bar bushings are rubber mounts that hold the bar down to the cradel. The bar runs though the mounts one each side where the bar and the cradel meet. If they are wore out you will normally hear a clucking noise from the front end when you hit bumps. To remove and replace them there is two bolts that hold a steel cap on top of them on each side. Remove the cap from both sides then the rubber mounts will have a split in them so you can get them off the bar. To install them is just the reverse of the removal. Good luck! 4 thumbs up is appeciated if this helps.

inspect control arm bushings

Check the sway bar links and ball joints.

The sway bar bushings are under the large clamps that hold the bar to the frame. The ends of the sway bar are connected to the struts by the sway bar links. When the links wear out, they clunk--not squeak. The bushings are under the retainer in the pic below.

very common problem is the sway bay end links that attach to the strut from the sway bar. They sound like a light chuckling knock over bumps. The bushings that hold the subframe up wear or the bolts loosed due to the bushings wearing. usually the rear ones The bushings are 2 piece ,upper and lower Tighten with 18mm socket

Check the macpherson struts to ensure they are not loose.  One way to check is visually in the engine compartment.  Check the top of the struts to ensure the nuts are not loose.  Another is to raise the side of the van where you hear the clunk.  Raise it so the wheel is off the ground.  Grasp and shake the strut to see if it is loose.  The struts should not be loose, but you never know.  As the strut is certainly ivnolved in bumps and rotates when the wheel turns, I would check there since you have already explored the bushings and links.

may be boll joint
or sway bar link .

I had the same problem with my 2002 Town and Country Limited. I took it to the mechanic and had the sway bar links and ball joints replaced and still had the same clunking noise when going over bumps at low speeds. The van sounded great on the highway, but country roads were horrible. I was about to replace the struts and pay another 700 dollars when i read somewhere that the sway bar bushings could wear and cause the noise. I took it to the mechanic and he said absolutely not it would be a waste of money. Being the stubborn guy I am, I went to NAPA and bought the two bushings for 12 dollars and replaced them myself in an hour. I took the van for a test ride and the noise is completely gone. Please ignore your mechanic and replace the bushings ASAP! Pretty cheap try even if it doesn't work.