Question about 2006 Volkswagen Jetta
How do i reset srs airbag indicator light
Posted on Nov 24, 2012
I have the air bag light on,jetta 06
Please how reset the light
Posted on Mar 11, 2014
Only dealer or a automobile repair facility can erase the light but keep in mind there is probably a issue going on to make that light to come on for a example srs control unit, seat belt buckle, side curtain airbags if equipped, seat weight sensors which are located in the passenger seat if there is a problem the light will not go out hope this helps
Posted on Mar 02, 2019
You need computer diagnostic equipment
Posted on Mar 02, 2019
The light will usually go out after the problem is no longer present..The Air Bag system does an internal system check every time the ignition switch is turned on. If not problems are detected the light will only do a bulb check the go out.
Posted on Feb 21, 2019
SOURCE: service now lights
With key off press and hold the 0.0 button on the cluster. With your other hand turn the key on while still holding 0.0 button press the minute button 1 second and you will see the service reset.
Posted on Dec 06, 2008
With the key in the ignition (but not turned), press and hold the Odometer Reset Button on the right hand side of the panel. While still holding that button, turn the key (although not far enough to start the engine) and then press and hold the Minute button on the left side of the instrument pane(if pressing doesnt work try turning the knob clockwise until service light has gone off and skip the pressing)l. Release both buttons at the same time.
Posted on May 30, 2009
The front seat buckles have a micro switch in them, you may have to split the plastic off to get t it and then check the wires are not broken and if ok then use electronic contact cleaner and hope it works for you if not the dealer would be glad to sell you the whole assembly
Posted on Feb 16, 2010
I have the same Problem. I Simply cut into the middle of the boot between the door and body The broken wire was right there, I pulled each end out and held the wire there with a pair needle nose pliers, stripped the end with a knife and attach a mulyi-strand jumper between both ends with electrial wire twists. Leave 2" approx. then slip the boot back over them. Use # 14 Wire. A Quick reasonable fix. If brakes again repeat again. The new Haness will have the same Problem down the road.
Posted on Apr 07, 2010
Testimonial: "I had the problem fixed at the dealer. It was the harness They made the harness longer & it was free.. "
Tips for a great answer:
Aug 06, 2014 | Volkswagen Jetta Cars & Trucks
Jan 20, 2013 | Cars & Trucks
Aug 10, 2009 | 2003 Volkswagen Jetta TDI
Jul 18, 2009 | 2001 Volkswagen Jetta TDI
Oct 17, 2017 | 2000 Volkswagen Jetta TDI
15,581 people viewed this question
Usually answered in minutes!