1999 GMC Safari Logo

Related Topics:

Nilo Oblefias Posted on Dec 23, 2017

99 gmc safari turnsignal and dashboard gauges went off , a power block on that cuircuit, but during start to ignition all gauges and signal works, but on engine start running and key switch back to running position all gauges and signal went OFF again, Truck is drivable but no signal... Please help...Thanks....

5 Related Answers

Anonymous

  • 2 Answers
  • Posted on Nov 29, 2008

SOURCE: 2000 GMC Jimmy will not start

The oil presure switch does have some bearing on the problem but my suggestion is to change the coil. I had a the same problem with an astro van. I changed everything that you have described and it fixed the problem just for a little while and then all of a sudden did it again. I changed the coild and the cold start swithch and never had the problem again.

Ad

Anonymous

  • 45 Answers
  • Posted on Jan 10, 2009

SOURCE: 2000 GMC Jimmy won't start

Hi: Have run into same type of problem, turned out to be a dead or very battery. Has nothing to do with the ignitin switch. With a low battery have also had trouble getting the key out of a 95 Jimmy. Boost unit to get running then discommect battery, if unit stall right away replace alternator, if stays running replace battery. If you get the unit runnimg and try to drive it as is you should find lacks power and wants to stall.

ratchethands

  • 66 Answers
  • Posted on Feb 04, 2009

SOURCE: 1996 GMC K1500 Pickup Starting Problem

i would try a fuel filter first. the fuel gauge going crazy is most likely the sender they go bad and eventually stop working. the bummer is you have to replace the fuel module. these aftermarket are about 200 bucks. the module comes with the pump and sender which is the next part you want to look at. gm has some issues with the harness to the fuel pump externaly. it actualy will melt and start to lose conection. i would check this by visualy inspecting the plug on top of the tank. unplug it and take a look. if it is at all disscolored replace the pump (module). the new pump comes with a replacement harness (make sure its in the box)hope this helps and good luck

Anonymous

  • 5 Answers
  • Posted on Apr 07, 2009

SOURCE: Engine sputtering now it wont start

sounds like the same problem i was just having try changing out your fuel regulator its pretty pricey try to find the cheapest around $75.

Anonymous

  • 8 Answers
  • Posted on May 28, 2009

SOURCE: 2000 GMC Sonoma starting problems

I would suspect the fuel pump

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Gmc turn signals

try removing the hazard switch this will allow turnsignal to work then see if the hazard switch was just stuck or needs replacing
0helpful
1answer

99 GMC Safari AC fuse has constant 12v even with key off.

power goes from htr a/c fuse to selector switch
and power to blower relay part of resistor module
when you plug resistor key off then no blower because htr fuse current coming from ignition switch
hope it helps
0helpful
1answer

I have a 2008HD GMC Sierra 4WD Diesel - I need power for my new pillar gauges. Which fuse in the cab fuse box will supply keyed accessory power and no power during ignition/cranking?

depending on what brand and style of gauges you use, you might want power with the key in the start position. I have Autometer electric gagues in my Ford diesel and the power is "on" anytime the key is on or in the start position. If you don't need power during the cranking cycle, then I would probably use the radio fuse.
0helpful
1answer

Ok, 2003 GMC Safari AWD 245,000 km. Drove 100km

sounds like an ignition switch glitch or ignition harness problem can be either depending on the amount of wear and tear with turning on and off of the ignition tumbler or possible chafing or inconsistent short in harness to ignition switch check the ground line up through harness first and check the wiring harness condition
0helpful
1answer

2002 GM Safari, no head lights at night. During

If it has a sensor in the dashboard try replacing that
1helpful
1answer

No start-95 safari

Could be fuel pump, is the pump running when you turn key on, you should be able to hear it. You are likely going to have to take it to someone with a pressure gauge to make sure it is getting proper fuel pressure. Fuel pumps commonly go on these vehicles
0helpful
1answer

Gas gauges and temp gauge stopped working on my 99 jimmy any idea

check fuse box,under your dashboard or hood.look for small print,that indicates the fuse operations
0helpful
1answer

98 GMC Safari has power but won't start

Have you checked battery voltage? (12v or better)
Check voltage at main starter cable (should be almost same reading, but not substantially lower (11.8 ok) Then check power to small terminal on starter...with key turned to "start" it should have 12v. If you have these readings and block ground is clean and secure, it's likely that starter has failed. If no power to small wire, either ignition switch or a relay is bad.(on stick vehicles add clutch switch) You can jump starter across large & small terminals and this will generally get it started. Do this with key "on" and vehicle in park (neutral on stick shift with brake on)
0helpful
1answer

1997 gmc safari gas guage stuck on full

if the gauge is still stuck when the van is off, try whacking the dashboard right above the gauge. PLEASE RATE MY ANSWER.
0helpful
1answer

1994 gmc safari

Sounds like your Passlock security system went into the tamper mode. If your dashboard security light blinks when the ignition is turned on, your Passlock security system is disabling the injector module, preventing the car from start. Try this:
1- turn the ignition on and just touch the starter, without getting the motor to fire, then leave the ignition in the "on" position. The security light will blink for about 10 minutes. When the light stops blinking, turn the ignition off and leave off for 3 minutes.
2-repeat the step #1, 3 or 4 times. You will know that is fixed when you turn the ignition on and the security light does not blink, then the car will start. Make sure to stay inside the car when you're doing this, as opening the doors will trip the security tamper mode on again. Once the tamper mode is off, the car starts and opening the doors will not trip the Passlock tamper mode.
Not finding what you are looking for?

64 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...